Module 0103-15 Introductions to hand tools Questions and Answers 100% Pass

Module 0103-15 Introductions to hand tools Questions and Answers 100% Pass Another name for a machinist's hammer is A. Ball-peen hammer B. Claw hammer C. Veneer hammer D. Sledgehammer - Answer- A. Ball-peen hammer A heavy-duty tool used to drive posts or other large stakes is a A. Mallet B. Sledgehammer C. Bell-faced hammer D. Ball-peen hammer - Answer- B. Sledgehammer The proper angle for the edges of a cold chisel is A. 90 degrees B. 60 degrees C. 45 degrees D. 30 degrees - Answer- B. 60 degrees The type of screw is shaped like a square (see picture) a A. Phillips head B. Torx C. Allen D. Robertson - Answer- D. Robertson Which of the following screws comes to a relatively sharp point at the base of its drive socket A. Reed and Prince B. Torx C. Allen D. Slotted - Answer- A. Reed and prince How many sides does a hexagonal shape have A. four B. five C. six D. seven - Answer- C. Six In what way is a spud wrench different from a pipe wrench? a. It is not adjustable. b. It has smooth jaws. c. It is significantly shorter. d. Using a handle extension is recommended. - Answer- B. It has smooth jaws To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a A. Striking Wrench B. Open-end wrench C. Speed Handle D. Breaker bar - Answer- C. Speed handle Another common name for lineman pliers is A. locking pliers B. Tongue-and-groove pliers C. Needle-nosed pliers D. Side cutters - Answer- D. Side cutters