API 510 Exam Questions and Answers 100% Pass

API 510 Exam Questions and Answers 100% Pass NDE examinations must be scheduled at intervals that consider the - Answer- Probability of the NDE method to identify the damage What is the transition temperature of a metal? - Answer- The temp at which the material fracture code changes from ductile to brittle A primary goal of API 510 internal inspection is to - Answer- Find damage that cannot be found by monitoring external CMLs When conducting a hydrostatic pressure test special attention should be given when testing low alloy steels especially 2 1/4 cr because - Answer- They may be prone to temper embrittlement What is the maximum chloride concentration allowed for water or steam when hydro testing 300 series - Answer- 50 ppm For austenitic stainless steel the susceptible temperature range of CUI is - Answer- 140 degrees and 400 degrees How many systems and procedures must be documented and implemented per API 510 in a owner user inspection repair management system for pressure vessels and pressure relief devices - Answer- 19 The consequence of a release is dependent on - Answer- The type and amount of process fluid contained in the equipment The surface at a weld with a joint factor the 1.0 is corroded. The calculation to determine if the thickness at the corroded are governs the allowable working pressure should be - Answer- The thickness of the surface of the weld includes 1" or twice the minimum thickness on either side of the weld whichever is greater A methodology whereby flaws and conditions contained within an equipment item are assessed in order to determine the integrity of the equipment for continued service is referred to as - Answer- Fitness for service evaluation What is a pressure vessel engineer responsible for - Answer- Activities involving design engineering review analysis or evaluation of vessels When can pressure tests of vessel components be performed in lieu of entire vessel testing - Answer- After consultations with an engineer An inspection plan shall be developed for - Answer- All pressure vessels and pressure relieving devices Which of the following techniques is specifically cited by API 577 as having special limitations due to concerns for incomplete fusion - Answer- GMAW -Spray transfer According to API 510 on stream inspections should be conducted by whom - Answer- An inspector or examiner