4th Class Power Engineering Unit A3: Introduction to Power Engineering and Its Governance in Canada Graded A+

4th Class Power Engineering Unit A3: Introduction to Power Engineering and Its Governance in Canada Graded A+ ASME code CSD-1 part CW-500 requires that all boiler have: Select one: a. control valves b. pressure relief valves c. blowdown valves d. air purge valves b. pressure relief valves ASME CSD-1 stands for: Select one: a. controls and safety devices for automatically fired boilers b. controls and safety devices for low pressure boilers c. controls and safety devices for high pressure boilers d. controls and safety devices for electric boilers a. controls and safety devices for automatically fired boilers This ASME code deals with recommended rules for the care and operation of heating boilers: Select one: a. ASME Section VI b. ASME Section V c. ASME Section I d. ASME Section VII a. ASME Section VI This part of the ASME Section IV covers the fundamentals of all heating boiler designs: Select one: a. Part HC b. Part HF c. Part HLW d. Part G d. Part G This section of ASME code deals with the recommended guidelines for the care of power boilers: Select one: a. ASME Section 1 b. ASME Section V c. ASME Section VI d. ASME Section VII d. ASME Section VII ASME 1, part PFT, deals with specific rules for the design and construction of: Select one: a. Welded Power Boilers b. Power Firetube Boilers c. Power Feedwater Heaters d. Power Watertube Boilers b. Power Firetube Boilers These are defined as boilers in which steam or other vapor is generated at a pressure greater than 100 kPag: Select one: a. Power boilers b. Pressure boilers c. Steam boilers d. Firetube boilers a. Power boilers This document is the mechanical refrigeration