AWS-CWI Part B Test 1 Questions With Correct Answers!!

There is a weld that was bent outside the bend radius of the shoe and no fracture on the bend. what should be done when this is noted? - Answer-Cut another specimen from the original specimen and bend it. All structural steel fillet welds that has a "W" (width) of 1" or greater shall have no convexitity greater than __________? - Answer-3/16" How should the weld reinforcement and backing be prepared prior to mechanical bending? - Answer-It shall be removed flush with the surface of the specimen. which of the following conditions shall cause inadequate penetration (IP) to be considered a defect? - Answer-The length of an individual indication of IP exceeds 1 inch. A welder was qualified in the 3G position, is he qualified to make a weld in the overhead position? - Answer-No, he is only qualified for the vertical, horizontal, and flat positions Cracked welds shall be cut out unless the repair is authorized by the company. when a crack repair is authorized for pipeline: - Answer-A double repair of a crack is not permitted what is the abbreviation for inside diameter? - Answer-ID What is the abbreviation for leak testing? - Answer-LT If a procedure qualification record is qualified on a plate test in the 3G position, does it qualify a welding procedure specification in all positions? - Answer-Yes, being as position is not listed as a procedure qualification variable on table 8. Arc burns on the parent metal shall not exceed ________ in length? - Answer-never accepted, regardless of their length What is an alternate term for weld face in the pipeline application? - Answer-Crown surface.When more than one welder is welding on the same test piece for qualification, failure of any portion of a single test weldment for performance qualification constitutes failure for what. - Answer-All processes used in the test, All welders in the test. True or False: the number of filler and finish beads should allow the completed weld substitutionally uniform cross section around the circumference of the pipe? - Answer-True