WRT Certification Exam with correct Answers 100%

WRT Certification Exam with correct Answers 100% The most critical course of action in restorative drying is to _______ ______ and begin __________ as soon as possible. - Answer ️️ -respond quickly & mitigation All restorers should follow the standard of care for the water restoration profession developed by the restoration industry entitled the IICRC ____. - Answer ️️ -S500 To help protect technicians from the many hazards associated with contaminated water losses, restorers need to have ready access to several items. These items protect for all _________ _________ to the body. - Answer ️️ -potential exposures Respiratory protection regulations state that the employer must provide: - Answer ️️ -1. Medical evaluations 2. Fit testing 3. Training The contract clearly states the agreement between the building owner and the restoration contractor. The form specifies who is responsible for payment and should be signed ______ work begins. - Answer ️️ -before The technicians first responsibility when arriving at a water damage site is to identify, communicate, and eliminate ______ _______ if reasonably possible. - Answer ️️ -safety hazards Federal regulations apply to the handling of ____ based paint and asbestos. - Answer ️️ -lead After safety concerns have been addressed and the initial water source has been stopped, the restorer must complete an evaluation of the water's migration through the structure. During this process, the restorer inspects all ___________ ________ areas. - Answer ️️ -potentially affected The ultimate goal is to find the "edge" of water migration, which moves in a three-dimensional path throughout the structure. This is accomplished across carpeted surfaces using a ________ ______, and across most hard surfaces using a ___-________ (non-penetrating) moisture meter. - Answer ️️ -moisture sensor & non-invasive Water from a clean source with no substantial risk of causing sickness of discomfort is said to be ________ _ water. - Answer ️️ -Category 1 Water that has a significant degree of chemical, biological, and/or physical contamination and a potential to cause sickness or discomfort is ________ _. - Answer ️️ -Category 2 Cleaning procedures must be employed before the drying of a Category 2 water loss can continue. At a minimum, affected ______ ________ (or pad) must be removed and disposed of, and carpet must be throughly cleaned using hot water extraction method. - Answer ️️ -carpet underlay When water intrusion results from a grossly unsanitary source or carries __________ (disease causing) agents, it is said to be Category 3. - Answer ️️ -pathogenic Workers and occupant ______ and safety are the first priority on every sewage loss. Areas affected by Category 3 water intrusion are marked and posted as potentially hazardous. - Answer ️️ -health Various cleaning and decontamination procedures must be used on Category 3 water losses, including the removal of all ______ ______ materials affected by the water intrusion. - Answer ️️ -highly porous When resistance is encountered and performing proper services in a Category 3 water loss becomes a challenge, restorers ____ ____ immediately to prevent liability and address the conflict. - Answer ️️ -stop work Third party experts are commonly referred to as Indoor Environmental Professionals, or ____. - Answer ️️ -IEPs Losses where regulated or hazardous materials have contaminated the structure do not change the _______ of water. - Answer ️️ -category Pre-existing conditions should be identified, documented, and communicated to all __________ __________ parties during the initial inspection. - Answer ️️ -materially interested When carpet delamination (the loss of integrity in the adhesives used to laminate the _______ and _________ backings) has occurred, further damage is very likely. For this reason, when extensive carpet delamintation is discovered, technicians must call it to the attention of all materially interested parties, document the condition and suggest ___________. - Answer ️️ - primary, secondary, & replacement There are a number of causes for carpet delamination -- many of them related to ________ restoration activities. - Answer ️️ -improper Typical causes of carpet delamination are: - Answer ️️ -1. Folding or stretching carpet when wet 2. Overly aggressive extraction 3. Improperly specified carpet underlay 4. Improper installation 5. Improper removal from tack strip 6. Improper floating of carpet 7. Excessive wear 8. Pet damage Many building materials will absorb excess water vapor and suffer damage, especially when air is allowed to remain above __% relative humidity. - Answer ️️ -60 Hygroscopic materials gain and lose moisture continually in an effort to ________ with the water content in the surrounding air mass. The more hygroscopic the material, the faster it will collect water vapor, and the easier it will suffer _________ damage. - Answer ️️ -equalize & secondary When water intrusion results in water running through wall cavities, inspection access holes are used to ensure that blow-in insulation has not compacted and lost its _-_____. - Answer ️️ -R- Value The most effective way to speed the drying process is to remove as much of the water in a liquid state as possible during the ___________ phase (for example, multiple extractions). Poor extraction will significantly slow the drying process. - Answer ️️ -extraction Abide by local ____ and regulations when disposing extracted water. Waste water is best disposed of into a sanitary sewer. - Answer ️️ -laws The primary goal of the initial extraction of the affected area is to contain further _________ of the water within the structure. - Answer ️️ -