Tooling u Test 1 Questions and Answers 100% Correct
Tooling u Test 1 Questions and Answers 100% CorrectTooling u Test 1 Questions and Answers 100% CorrectTooling u Test 1 Questions and Answers 100% Correct What must a programmer do to calculate the X-axis location of the start of the partial arc shown? The programmer must find the length of - ANSWER-Side a, double it, and subtract that amount from the workpiece face diameter. A standard twist drill has a 0.50 in. (12.70 mm) diameter. What trigonometric calculations can be used to find the accurate drill depth? - ANSWER-Find the length of the shortest side of the right triangle, side b, that is formed at the drill tip, using the ratio tan 59°=0.25 in. (6.35mm)/a. What is the purpose of adding an approach to a cut? - ANSWER-It increases safety. What is the difference between the R method and the I and K method of programming arc motions? - ANSWER-The R method uses the radius size, while the I and K method
Written for
- Institution
- Tooling u
- Course
- Tooling u
Document information
- Uploaded on
- February 29, 2024
- Number of pages
- 6
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers
Subjects
-
tooling u test 1 questions and answers stuvia
-
what must a programmer do to calculate the x axis
-
a standard twist drill has a 050 in 1270 mm d
Also available in package deal
