S-95 supervision of fire alarm systems Questions and Answers with complete

Fire alarm system and/or building occupancy Fire alarm system has two way voice communication, with warden phone System installed in a high rise building System with one and/or two way communication installed in a hotel building with 50 or more sleeping rooms - Answer-C of F - FSD Fire alarm system and/or building occupancy Fire alarm system in a homeless shelter not requiring a FSD - Answer-C of F - F-80 Fire alarm system with one way communication system, not requiring a FSD/F-80 Fire alarm system without voice communication system and not requiring a F-80 - Answer-C of F - S- 95 Fire alarm systems which include to the following buildings: - Answer-Office buildings Shelters Hostpitals Marinas Commercial Hotels Schools Apartment building as specified in Building code section 309.1The primary purpose of fire alarm systems Whity in protected premises is to... - Answer-Warn bulding occupants and transmit signals indicating a fire condition to the fire department via an fdny approved central station company. Fire alarm control panel FACP - Answer-The primary purpose of the fire alarm control panel is to process signals received from initiating devices and to activate appropriate signals and outputs. Three types of signals initiated by Facp - Answer-Fire alarm signal Supervisory signals Trouble signals Fire alarm signal - Answer-A signal initiated by a fire alarm initiating device such as a manual fire alarm pull station, smoke detector, water-flow switch, or other drvice in ehich activation is indicstivr of the presence of a fire. Supervisory signals Are generated from initiating devices such as: - Answer-Valve supervisory switch on a sprinkler system High/low water level switch on a gravity tank feeding a sprinkler system Low air pressure switch from a dry pipe sprinkler system Fire pump running/pump failure/pump phase reversal The FDNY is not dispatched to respond to supervisory signals because? - Answer-Supervisory signals are not indivative of a fire condition. Trouble signals - Answer-Trouble signals indicate that the alarm system, transmitter, or communications path is wholly or partially out of service. Common reasons:Battery conditions Ac failure Ground fault Open or short circuit on a wire Phone line failure Internal component failure Trouble signal The central station shall communicate immediately with the person designated by the subscriber. Routine handling should take a maximum of... - Answer-4 minutes