MSSC- M3 Machine Tooling Questions and Answers Graded A+

MSSC- M3 Machine Tooling Questions and Answers Graded A+ During the drilling of a hole, the drill is raised to - Answer ️️ -clear the chips from the hole To drill a hole in a part, the _ of the circle is indicated with layout lines - Answer ️️ -center point Which of the following is not a part of the twist drill? - Answer ️️ -chip breaker Which of the following is an example of an unsafe practice while operating a drill press? - Answer ️️ -Stooping down to look closely at the part and drill, as the drill enters the metal to make sure it's positioned properly A drill press - Answer ️️ -uses a rotating tool to cut into material A drill press is used to - Answer ️️ -create holes Engineers sometimes use a _ to measure angles on a drawing - Answer ️️ -protractor The size of a drill is usually stamped on its - Answer ️️ -shank Which of the following is an example of an unsafe practice while setting up the drill press? - Answer ️️ -Examining a large part and deciding to hold it in place by hand since it's so large, it will not fit in the vise Layout work is the operation of - Answer ️️ -transferring date from a technical drawing to the part Which of the following is not commonly used oil for creating a cutting fluid? - Answer ️️ - Motor