MSSC Quality Questions and Answers Already Graded A

MSSC Quality Questions and Answers Already Graded A A scale typically found on a tape measure is ______ - Answer ️️ -1/16 Two systems of dimensional measurement used in manufacturing are the SI Metric System and the _____ - Answer ️️ -US Customary System A common decimal-inch graduation is _____ - Answer ️️ -10ths, 50ths, 100ths Resolution is sometimes called ____ - Answer ️️ -discrimination A common scale on a machinist's rule is _____ - Answer ️️ -150 mm Dimensional measurement determines physical dimensions such as - Answer ️️ -width, height, depth, and diameter If the length of a part is 5.000 inches and the reading could be as much as 5.002 or as little as 4.998, the accuracy is said to be ______ inches - Answer ️️ -+/- 0.002 A common fractional-inch rule graduation is in _____ - Answer ️️ -32nds A tape measure is used _____. - Answer ️️ -In manufacturing and construction industries ____ error occurs when the measurement we think we see is not the measurement being indicated by the instrument - Answer ️️ -Observational The conversion of 3-3/8 inches to decimal inches is _____ - Answer ️️ -3.375 inches The first step in dimensional measuring is to align the end of the rule where the zero is located with one edge of the dimension you want to measure. The edge is called the ______ - Answer ️️ -reference point One inch is equal to - Answer ️️ -25.4 mm In a standard multi-view drawing arrangement, the rear view is drawn to the _____ of the left side view - Answer ️️ -left