NFPA 96 Questions and Answers 100% Pass

NFPA 96 Questions and Answers 100% Pass 4.2.1 Where enclosures are not required, what are the clearance requirements? 18" to Combustible 3" to limited-combustible 0" to non-combustible 4.1.8 All interior surfaces of the system shall be accessible for what? Cleaning and Inspection 5.1.2 All seams, joints, and penetrations of the hood enclosure shall have a what in regards to their construction? liquidtight continous external weld to the hoods lower outermost perimeter. 6.1.3 Mesh filters are ok on older hoods. False 6.2.1.2 The lower edge of the filters in hoods above charbroilers must be what distance from the charbroiler surface? 4 ft minimum 6.2.1.1 The distance for filters to cooking surface on everything but charbroiler is? 18" minimum but as far as possible. 5.3.4.3 What is the max temp for a fire damper activation? 286 degrees F. 6.2.3.4 What is the minimum angle a filter can be installed? 45 degrees from the horizontal 6.2.4.3 What is max capacity for a grease drip tray under the filters? 1 gallon 7.3.1 Openings for access panels shall be located where: at the sides or top of duct. Whichever is more accessible. 7.1.4 All ducts shall be installed without forming dips or traps that can collect grease. True 7.3.4 For hoods with dampers how close does an inspection panel need to be installed to the damper? 18" 7.3.7 Exhaust fans with ducts connected from both fans shall have access panels where? 3' or closer on each side of the fan 7.4.2.3 On nonlisted ductwork, the edge of the opening (for an access panel) shall be not less than ____ from all outside edges of the duct or welded seams? 1.5" 7.4.3.1 Access panels shall be how thick? same thickness and material of the duct. 7.4.3.2 What is the minimum temp rating for an access panel? 1500 degrees (also needs to be grease tight) 7.4.3.3 It is okay for access panel screws to penetrate the duct False 7.5.1.1 How thick does the metal of ducts need to be? 16 gauge steel or 18 gauge SS 7.8.2.2 Fans shall be provided with: safe