OSHA 30 Questions and Answers Already Passed

OSHA 30 Questions and Answers Already Passed Hazard or mitigation controls may be short and/or long term True Hazard prevention and control should contain both Human and administrative resources A safety and health program is called a living document why A safety and health program changes as an organization changes What should an incident investigation program include All the above I'm general accidents and incidents are caused by unsafe or hazardous conditions and Unsafe or unhealthy actions and behaviors Who should be on the team that evaluates a safety and health program All the above Who should be involved in communication and coordination of safety and health programs All the above Managers are considered what within an organization when it comes to safety and health Agents of change What is the ideal time for conducting witness interviews during an incident investigation As promptly as possible since memories fade over time Which of the following is an incident that should be investigated All the above Of the following who should be the best choice to write your organization safety and health program Safety and health subject matter expert You have been investigating an incident where a worker was struck in the head by a flying scrap of wood from a table saw which of the following corrective actions might be the most appropriate Table saws must always have guards installed Which of the following is a benefit for having a safety and health program A company may need to bid on a contract that requires safety and health documentation When should a formal hazard assessment or inspection be performed When a new hazard is uncovered Which of the following is a line role with regard to an organizations safety and health program Implementing and maintaining the safety and health program Which of the following statement are true about incidents Nearly all workplace incidents are wholly preventable Personal fall arrest hooks must be locking and Designed to prevent opening and slipping off the connector Personal fall arrest system connectors must be compatible and capable of supporting at least 5000 pounds If there are defects found during the inspection of personal fall protection equipment or if the equipment has been used in an arrest it must be Removed immediately from service Three major components of personal fall arrest sustain anchor and the anchorage connector full body harness and Connecting device Horizontal lifelines shall be designed installed and used under the supervision of a what as part of a complete personal fall arrest system which maintains safety factor of at least two Qualified person Fall restraint systems must meet which of the following criteria All the above It is important to secure your ladder whenever feasible to Fixed and secure points OSHA and ladder manufacturers require which of the following when ascending or descending 3 points of contact The three main types of portable ladders are Step straight and extension The 4:1 angle rule for extension ladders means which of the following For every 4ft of the ladder it should be 1 for away from the wall Protect yourself while working in a ladder by All the above When using scaffolds make sure there is All the above Supported scaffold systems must be inspected for Both b and c Every supported scaffold and it's components must support without failure it's own weight and at least what the intended load 4 times The guardrails on suspended scaffolds manufactured after the year 2000 must be how long with mid rails installed approximately halfway between the top rail and the platform surface 38 and 45 inches high A what must be available to direct workers who are constructing a moving scaffolds Competent person Employees must not work on scaffold surfaces until The surface are determined to have the strength and structural integrity to support their