ASE A3 Questions and Answers 100% Pass
ASE A3 Questions and Answers 100% Pass Noise: In gear, clutch disengaged (pedal to floor) - Answer ️️ -Pilot bushing or bearing Noise: Neutral, clutch disengaged (pedal to floor) - Answer ️️ -Release bearing Noise: Neutral, clutch engaged (pedal up) - Answer ️️ -Input shaft bearing Binding U-Joint will damage?? - Answer ️️ -Extension housing bushing and seal What is used to check the clearance between the shift fork and the synchronizer sleeve? - Answer ️️ -A feeler guage Warped pressure plates... - Answer ️️ -... should be replaced Ring and pinion gears... - Answer ️️ -...should be replaced as a set What tool is used to measure ring gear runout? - Answer ️️ -A dial guage How many times can a collapsible sleeve be tightened? - Answer ️️ -Once, and must be replaced if over tightened. What tool is used to check pinion bearing preload? - Answer ️️ -Inch pound torque wrench
Written for
- Institution
- ASE
- Course
- ASE
Document information
- Uploaded on
- January 15, 2024
- Number of pages
- 4
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers
Subjects
-
ase a3 questions and answers 100 pass
Also available in package deal