CSMLS Safety Manual Practice Questions with complete solutions.

CSMLS Safety Manual Practice Questions with complete solutions. What are the major ways to deal with risk? a. ignore them, make employees sign non-liability contracts b. worker's compensation c. report to government d. tolerate, treat, terminate or transfer the risk - correct answers.d. tolerate, treat, terminate or transfer the risk Name the 5 categories of hazards: - correct answers.1. chemical 2. biological 3. physical 4. ergonomic 5. psychological Which of the following may be useful in helping to identify laboratory hazards? a. safety data sheets b. inspections c. incident reports d. all of the above - correct answers.d. all of the above Personal monitoring can be used to measure noise exposure. a. true b. false - correct answers.a. true Standards for all chemicals that identify allowable levels of exposure are available. a. true b. false - correct answers.b. false Threshold Limit Values were devised to identify the level of risk for the most sensitive individuals in the in the workplace. a. true b. false - correct answers.b. false An example of an engineering control is: a. full body coverage with gown, shoe covers, gloves and goggles b. strictly enforced safety rules c. all of the above d. none of the above - correct answers.d. none of the above Emergency response plans, training and occupational health programs are examples of: a. engineering controls b. administrative controls c. personal protective equipment d. none of the above - correct answers.b. administrative controls In the "hierarchy of controls", which type of control is considered the best? a. engineering controls b. administrative controls c. PPE d. hiring controls - correct answers.a. engineering controls A Task Hazard Analysis: a. is required for each job by federal regulations b. is a good approach to identify hazards c. should be done by supervisors and managers rather than workers d. is not a part of an occupational health and safety management system - correct answers.b. is a good approach to identify hazards The concept in legislation that indicates that "employers must do everything reasonable to protect the health and safety of workers" is referred to as: a. the rights of workers b. refusal of unsafe work c. due diligence d. worker's compensation - correct answers.c. due diligence In the Internal Responsibility System model, management is usually required to: a. Correct hazards b. Provide training