Journeyman Oil Exam Questions and Answers | 100% Correct

Journeyman Oil Exam Questions and Answers | 100% Correct TT terminals are normally used for? A. Line 1 B. Neutral C. Thermostat D. Burner load - Answer ️️ -C. Thermostat The stack mount primary control must be ______ prior to use. A. Stepped on B. Put in step C. Reset D. None of the above - Answer ️️ -B. Put in step The ECM (electrically commuted motor) features: A. Quicker shut-off B. Quicker starting C. Variable speed motor capability D. All of the above - Answer ️️ -C. Variable speed motor capability The cad cell control will go to the lock out position when a reading of _______ ohms are found at the cad cell. A. 300 B. 700 C. 2000 D. 1600 - Answer ️️ -D. 1600 When the FF terminals are jumped after starting up and the controls goes into lock out what is the correct action? A. Reset control B. Jump out TT C. Replace control D. Replace cad cell - Answer ️️ -C. Replace control The following factors affect cad cell performance except: A. Cell alignment B. Dirty cell C. Improper flame D. Thermostat setting - Answer ️️ -D. Thermostat setting A switching relay can be used to A. Control a line voltage device with low voltage contr