Sense level 1 welding process certification test module 9 Questions With Complete Answers.

Which of the following is not a type or weld joint - Fillet The portion of the joint where the two pieces to be joined come closest together is called the - Joint root A weld produced by filling an elongated hole in an overlapping member fusing is to the member beneath is called a - slot weld a weld having a triangular cross section which is applied to the t joint corner joint or lap joint is called a - Fillet weld a weld used to build up thin surfaces and to provide a layer of corrosion protection and or abrasion resistance is called - surfacing weld the height of a weld above the base metal in a groove weld is the - weld reinforcement a _____________ Fillet weld has the same leg and size dimensions - equal leg a weld formed by progressing along the joint with a side to side motion is called a - weave bead the base material nest to the weld that is not melted but that undergoes structural and metallurgical changes is called - heat affected zone the problem occurring in weldments due to the non uniform heating produced by welding is called - distortion the most common type of destructive testing of welds is called - bend testingaccording to the AWS D1. 1 code, if a welder continues to use a particular procedure how long does his qualification remain in effect - indefinitely unless the ability of the welder is questioned. A weld discontinuity caused by the improper termination of the welding arc is referred to as - a crater crack a Discontinuity that results from the entrapment of gas within the weld is referred to as - Porosity which weld metal discontinuity is generally considered to be the most severe - Crack which weld discontinuity results from weld metal flowing out of the joint and laying on the base metal surface without fusing - overlap