OSHA 511 GENERAL INDUSTRY-FM EXAM WITH VERIFIED SOLUTIONS.

What is a result of workplace injuries and illnesses? Lower morale and increased costs What is OSHA's mission? Protect safety and health of workers Brainpower Read More Previous Play Next Rewind 10 seconds Move forward 10 seconds Unmute 0:01 / 0:15 Full screen What is 11(c) of the OSHA Act? Whistleblower protection What is the difference between a horizontal and vertical standard? Horizontal standards generally apply to all industries----vertical standards apply to specific industries---- if a condition is not covered under a vertical standard, it may revert back to the horizontal standard. What is a CPL, STD or other Directive? Documents to clarify OSHA standards and hopefully ensure consistent enforcement of the standards. What is OSHA'S multi-employer policy? On sites where more than one employer is working, this policy address possible citations to employers who expose their employees to a hazard; create a hazard; have control of a hazard; or have the ability to correct a hazard. What is "abatement"... must the employer abate citations? Employer must abate (correct) all finalized citations. What are the four parts to an OSHA inspection? Present credentials, opening conference, walk-around, and closing conference. For the 300 Log, if a worker could only work a partial day... what type of case is that? Restricted What is an incidence rate? The number of recordable injuries and illnesses per 100 full-time workers. What are good examples of management leadership? Lead by example; know and follow the rules; and provide resources for safety. What is a proactive approach of identifying and correcting hazards in a workplace? Regular reviews of company policies and procedures to make improvements. What is a floor hole? A gap or opening measuring 2 inches or more. As a general rule, fall protection must be provided at ______ feet or more... in general industry workplaces? 4 feet When is a ladder safety system required on a fixed ladder? Fixed ladders requiring a climb of > 24 feet. In planning for emergency exits... what is an important consideration ? The specific number of personnel... provide an adequate number of exit routes. When can an employer orally communicate the Emergency Action Plan? When they have 10 or fewer employees. For Class A Fires, extinguishers must be located within ____ feet of the employee? 75 Feet What determine different categories of flammable liquids? Flashpoint and boiling point What are the three basic means of safeguarding machinery? Devices, guards, and location. In machine guarding, what is meant by "point of operation? Point where cutting, shaping, boring, or forming is accomplished. What are common hazards associated with conveyors? Nip points and rotating parts. If a filtering face piece is required to be worn by the employer, are they subject to the same requirements as other air-purifying respirators? Yes What approval standards apply to eye, head and foot protection? National consensus standards --ANSI and ASTM. Most personal protective equipment must be paid for by ___________? The employer. Electrical interconnection (bonding and grounding) is required when dispensing what Categories of flammable liquids? Category 1, 2, or 3 (flashpoint below 100 degrees F). What is meant by LFL and UFL? Lower flammable limit and upper flammable limit. What is LFL? The minimum concentration of a gas or vapor that will burn in air. Below this level, the mixture is too "lean" to burn. What is UFL? The maximum concentration of a gas or vapor that will burn in air. Above this level, the mixture is too "rich" to burn. The range between the LFL and UFL is known as ? The flammable range for that gas or vapor. Which industry standard does OSHA incorporate by references for handling of compressed gas cylinders? Compressed Gas Association --- CGA Pamphlet P-1