OSHA 511 GENERAL INDUSTRY PRACTICE EXAM QUESTIONS AND ANSWERS 2024

Workplace injuries and illnesses may result in low morale lost of training replacing workers OSHA mission is to protect workers safety and health Brainpower Read More Section 11(c) of OSH Act gives workers the right to a safe and healthy workplace without fear of punishment When a condition is not covered by industry specific standards horizontal standards apply Enforcement and compliance directives ensure consistent and enforcement of regulations Employers must certify the abatement of each cited violation Under the multi employer citation policy, a creating employer would receive a citation for failure to inform Employers of a damaged guardrail. Employer of other employees of a guardrail they damaged exposing all employees to a fall. Inspection process includes - presentation of credentials - opening conference - walk around inspection - closing conference Days an employee was able to work a partial work shift would be classified as restricted work activity if a result of work related illness or injury A record keeping incident rate is the number of is the number of recordable injuries and illnesses per 100 full time employees To demonstrate leadership and commitment to safety and health managers should be an example by knowing and following the rules employees are expected to follow Performing periodic review of company policies and procedures to identify need for improvement is the best way an effective safety and health management system promotes a proactive approach in the workplace A floor opening measures 12 inches or more in its least dimension a person may fall through Permanent aisles and passageways shall be appropriately marked and kept clear and in good repair to prevent being struck by hazards Cages and wells shall be required for fixed ladders that are more than 20 feet to a maximum unbroken length of 30 feet An adequate number of exit routes is the most important factor in providing employees safety during an emergency Only employers with 10 or fewer employees may orally communicate an emergency action plan A class A extinguisher shall be located no more than 75 feet from employees Flash point and boiling differentiate 4 categories of flammable liquids Three basic means of safeguarding machinery are devices guards locations Point of operation is the point at which cutting, shaping, boring or forming is accomplished. Nip points and rotary parts are the most common conveyer hazards Filtering of face piece dust mask respirators are subjected to the same requirements as other purifying respirators when required to be worn Eye head and foot PPE must comply with National Consensus Standards ANSI With few exceptions PPE must be paid for by the employer When dispensing category 1 or 2 flammable liquids An Electrical interconnections is required The lower flammability level of a gas or vapor of a flammable liquid is the lowest concentration in the air expressed as a percentage, that can be ignited The CGA Pamphlet 1 has been incorporated by reference for handling use and storage of compressed gases Industrial Hygiene principles, are concerned with recognition evaluation and control of chemical, biological, physical and ergonomic hazards that may cause sickness or impaired health