OSHA 511 GENERAL INDUSTRY EXAM QUESTIONS AND ANSWERS 2024.

Workplace injuries and illnesses may result in low morale lost of training replacing workers OSHA mission is to protect workers safety and health Brainpower Read More Previous Play Next Rewind 10 seconds Move forward 10 seconds Unmute 0:01 / 0:15 Full screen Section 11(c) of OSH Act gives workers the right to a safe and healthy workplace without fear of punishment When a condition is not covered by industry specific standards horizontal standards apply Enforcement and compliance directives ensure consistent and enforcement regulations Employers must certify the abatement of each cited violation Under the multi employer citation policy a creating employer would receive a citation for failure to inform employers of a guardrail employer of other employees of a guardrail they damage exposing all employees to a fall Inspection process includes presentation of credentials opening conference walk around inspection closing conference Days an employee was able to work a partial work shift would be classified as restricted work activity if a result of work related illness or injury A record keeping incident rate is the number of is the number of recordable injuries and illnesses per 100 full time employees To demonstrate leadership and commitment to safety and health managers should be an example by knowing and following the rules employees are expected to follow Performing periodic review of company policies and procedures to identify need for improvement is the best way and effective safety and health management system promotes a proactive approach in the workplace A floor opening measures 12 inches or more in its least dimension and persons may fall through Permanent aisles and passageways shall be appropriately marked and kept clear and in good repair to prevent struck by hazards Cages and wells shall be required for fixed ladders that are more than 20 feet to a maximum unbroken length of 30 feet An adequate number of exit routes is the most important factor in providing employees safety during an emergency Only employers with 10 or fewer employees may orally communicate an emergency action plan A class A extinguisher shall be located no more than 75 feet from employees Flash point and boiling differentiate 4 categories of flammable liquid Three basic means of safeguarding machinery are devices guards locations Point of operation is the point at which cutting shaping and boring of forming is accomplished Nip points and rotary parts are the most common conveyer hazards Filtering of face piece dust mask respirators are subject to the same requirements as other are purifying respirators when required to be worn Eye head and foot PPE must comply with National Consensus Standards ANSI With few exceptions PPE must be paid for by the employer When dispensing category 1 or 2 flammable liquids Electrical interconnections is required The lower flammability level of a gas or vapor of a flammable liquid is the lowest concentration in air expressed as a percentage that can be ignited The CGA Pamphlet 1 has been incorporated by reference for handling use and storage of compressed gases Industrial Hygiene principles are concerned with recognition evaluation and control of chemical, biological, physical and ergonomic hazards which may cause sickness or impaired health Upon initial assessment and when new physical or health hazards are introduced in the work area employers are required to provide information and training of hazardous chemicals to employees The blood borne pathogens standard applies to occupational exposure to blood or other potentially infectious materials Engineering controls do not include job rotation During spray painting and blasting degreasing and other operations the most common route of entry of hazardous chemicals into the body is inhalation A skin notation indicates that a chemical can be absorbed through the skin and substantially add to the total dose Effective exhaust ventilation draws contaminated air away from workers breathing zone An effective hearing conservation program is required when employee noise exposure equals or exceeds an 8 hour time weighted average of 85 decibles Power industrial truck operators must receive truck operators and safety training and be evaluated in truck operations and have their performance evaluated at least once every three years Cranes may be modified and rerated if the supportive structure is checked by a qualified engineer or the equipment manufacturer for the new rated load Synthetic swings are required to be removed from service When the sling has been exposed to acid or costic burns