ASNT VT Level II Exam Questions With 100% Correct Answers.

ASNT VT Level II Exam Questions With 100% Correct Answers. Localized reduction in an area of a bolt that is under overload conditions is referred to as : necking down . The least common location for fastener failure is : in the midgrip Discontinuities that are produced during the hot or cold working of the ingot into rod or bar to make studs are called : primary processing discontinuities Service induced discontinuities in bolting systems may be produced by : vibration, over-tensioning, and corrosion. The fillet weld size is based on the: length of fillet weld leg. A convex weld surface : curves outward During the solidification of metal , a hole produced due to escaping gases is called a : blow hole Weldments might contain incomplete penetration A discontinuity typically found in forgings is : laps