CDC Y2T35X vol.1 EXAM QUESTIONS AND ANSWERS

The bushing or bearing that supports the forward end of the transmission input shaft is called the A. Release bearing B. Clutch bearing C. Input bearing D. Pilot bearing - Answer- D. Pilot bearing How is the friction material attached to the clutch disk A. Glued to both sides of the disc B. Riveted to both sides of the disc C. Bolted to the backside of the disk D. Held by springs to the front side of the disk - Answer- B. Riveted to both sides of the disc How is the clutch pressure plate mounted A. Pressed onto the transmission input shaft B. Pressed onto the clutch hub C. Bolted to the fly wheel face D. Bolted to the bell housing - Answer- C. Bolted to the fly wheel face The clutch release (or throw out) bearing is held by small spring clips on the A. clutch fork B. Clutch disk C. Pressure plate D. Engine fly wheel - Answer- A. clutch fork The clutch housing (or bell housing) may be made of any of the following except A. Cast-iron