NCIDQ – IDPX Questions and Answers Already Passed

NCIDQ – IDPX Questions and Answers Already Passed NB: Answers to respective questions appear before the questions and are highlighted in yellow A: Door Schedule Where would it be best to call out the frame material on an entry door? A. door schedule B. finish schedule C. hardware schedule D. finish plan A: 'I' should be used for interior design sheets when an architect's drawings are included as part of the drawing set 'I' is most commonly used when architectural drawings are also included in a drawing set, as a means to easily distinguish between architectural and interiors work. When would be most appropriate for an interior designer to use the prefix letter ‘I’ when numbering a set of construction drawings? A: ‘I’ should be used for interior design sheets when an architect’s drawings are included as part of the drawing set B: ‘I’ should be used for small interior design projects only C: 'I’ should never be used; the letter ‘A’ should always be used for any sheets pertaining to either architectural or interior design D: ‘I’ should always be used for all interior design sheets in a drawing set B: List the information in a proprietary specification. A proprietary specification calls out one single item by brand name, manufacturer, and model number. Proprietary specifications are the most restrictive as they give the interior designer complete control over what is to be installed in a project. Sometimes the specifications include an "or equal" clause (referred to as a "base-bid specification"), which means the substitution of other products will be allowed if the contractor thinks they are equal to the one specified. With a proprietary specification, the interior designer can also require that a sample be submitted to further verify that the item meets the project needs, but requesting a sample alone is not the best way. What is the best way for an interior designer to ensure that the exact product desired will be used in the final design? A: Require that the contractor submit samples of all items before purchasing. B: List the information in a proprietary specification. C: Show the configuration of the product on the drawings, and call it out specifically. D: Write a closed, descriptive specification. B: wall-to-wall carpeting Carpeting is a finish item (like paint or ceiling tile) that is attached to the construction and is typically part of the construction contract. Even though a sculpture is physically attached to the construction, it is commissioned directly with the artist and may be included in the FF&E budget. Vertical blinds are sometimes included in the construction contract but not as commonly as wall-to- wall carpeting is. Vending machines can also be part of a construction contract, but if there is both a construction and FF&E contract, they are usually part of FF&E. Although all four of the items mentioned may be part of either contract as the client wishes, the question asks which is generally not. Which of the following is generally NOT considered FF&E? A: vertical blinds B: wall-to-wall carpeting C: a commissioned sculpture bolted to a wall D: vending machines built into an opening C: Base-bid specifications A base-bid specification calls out a proprietary material or product but allows substitutions. An interior designer can use the term or "approved equal". In a base-bid specification to ensure that any substitutions submitted are of equal quality and gives the chance for the interior designer to review and approve any substitutions prior to being incorporated into the bid. In which type of construction specification is the term “approved equal” most likely to be used? A: Performance specifications B: Descriptive specifications C: Base-bid specifications D: Proprietary specifications D: book match Only book matching and slip matching refer to the ways individual veneer pieces can be laid up next to each other. Of these two options, book matching is generally considered the preferred, most pleasing match. When specifying the method by which two veneer pieces are to be applied, the most pleasing result is usually obtained with a: A: random match B: balance match C: slip match D: book match Millwork section What type of drawing is shown in this image? C: