Module 12 SMAW - Open-Root Groove Welds - Plate (29112-15)with 100% correct answers

A​ double-groove weld is identified by​ _____. grooves on both sides of the joint A bevel radius is associated with which two types of groove​ welds? ​J- and​ U-groove welds Groove weld size can never be greater than the base metal thickness. True Maintain a short arc when using​ low-hydrogen electrodes because​ _____. they do not produce a heavy gaseous shield Although the range can vary based on a number of other​ factors, a typical amperage range for 3/32′′ ​(2.4 mm) E6010 electrodes is​ _____ amps. 40 to 80 Root reinforcement on​ open-root V-groove welds should be flush to​ _____ thick. 1/8′′ Which of the following is not a factor that affects keyhole​ size? Bevel radius Groove welds with an undercut are acceptable as long as the undercut does not exceed 1/4′′. False To help tack welds fuse into the root​ pass, they should be​ _____. feathered with a grinder When welding a​ V-groove in the vertical​ position, set the amperage of the welder to the higher part of the range for better puddle control. False When using weave beads for a 3G position​ weld, the beads should be no more than five times the width of the electrode. True The portion of the edge of a part to be joined by a groove weld that has not been beveled or​ grooved; previously referred to as the land is a​ ________. Root Face