Cisco Final Exam

What is the correct order for PDU encapsulation? - Answer- Frame Header-Network Header-Transport Header-Data-Frame Trailler A PC is configured to obtain an IP address automatically from network 192.168.1.0/24. The network administrator issues the arp -a command and notices an entry of 192.168.1.255 ff-ff-ff-ff-ff-ff. Which statement describes this entry? - Answer- This is a static map entry Which two notations are useable nibble boundaries when subnetting in IPv6? - Answer- */64 */68 What will a Layer 2 switch do when the destination MAC address of a received frame is not in the MAC table? - Answer- It forwards the frame out of all ports except for the port at which the frame was received. Which two statements correctly describe a router memory type and its contents? - Answer- *RAM is volatile and stores the IP routing table. *ROM is nonvolatile and contains basic diagnostic software. What is the auto-MDIX feature on a switch? - Answer- the automatic configuration of an interface for a straight-through or a crossover Ethernet cable connection What is the purpose of the routing process? - Answer- to select the paths that are used to direct traffic to destination networks What is the purpose of ICMP messages? - Answer- to provide feedback of IP packet transmissions Open the PT activity. Perform the tasks in the activity instructions and then fill in the blank. The Server0 message is - Answer- Winner Refer to the exhibit. Which IP addressing scheme should be changed? - Answer- Site 2 Which subnet would include the address 192.168.1.96 as a usable host address? - Answer- 192.168.1.64/26 Which subnet would include the address 192.168.1.192 as a usable host address? - Answer- 192.168.1.128/25 An administrator uses the Ctrl-Shift-6 key combination on a switch after issuing the ping command. What is the purpose of using these keystrokes? - Answer- to interrupt the ping pr