CCNA 2 v7 final Exam Questions and Answers graded A+

CCNA 2 v7 final Exam Questions and Answers graded A+ Refer to the exhibit. What will router R1 do with a packet that has a destination IPv6 address of 2001:db8:cafe:5::1? forward the packet out Serial0/0/0 Refer to the exhibit. Currently router R1 uses an EIGRP route learned from Branch2 to reach the 10.10.0.0/16 network. Which floating static route would create a backup route to the 10.10.0.0/16 network in the event that the link between R1 and Branch2 goes down? ip route 10.10.0.0 255.255.0.0 209.165.200.225 100 Refer to the exhibit. R1 was configured with the static route command ip route 209.165.200.224 255.255.255.224 S0/0/0 and consequently users on network 172.16.0.0/16 are unable to reach resources on the Internet. How should this static route be changed to allow user traffic from the LAN to reach the Internet? Change the destination network and mask to 0.0.0.0 0.0.0.0 Which option shows a correctly configured IPv4 default static route? ip route 0.0.0.0 0.0.0.0 S0/0/0 Refer to the exhibit. Which static route command can be entered on R1 to forward traffic to the LAN connected to R2? ipv6 route 2001:db8:12:10::/64 S0/0/1 fe80::2 What is a method to launch a VLAN hopping attack? introducing a rogue switch and enabling trunking A cybersecurity analyst is using the macof tool to evaluate configurations of switches deployed in the backbone network of an organization. Which type of LAN attack is the analyst targeting during this evaluation? MAC address table overflow Refer to the exhibit. A network administrator is configuring a router as a DHCPv6 server. The administrator issues a show ipv6 dhcp pool command to verify the configuration. Which statement explains the reason that the number of active clients is 0? The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation. Refer to the exhibit. A network administrator configured routers R1 and R2 as part of HSRP group 1. After the routers have been reloaded, a user on Host1 complained of lack of connectivity to the Internet The network administrator issued the show standby brief command on both routers to verify the HSRP operations. In addition, the administrator observed the ARP table on Host1. Which entry should be seen in the ARP table on Host1 in order to gain connectivity to the Internet? the virtual IP address and the virtual MAC address for the HSRP group 1 Match the forwarding characteristic to its type. (Not all options are used.) Picture Which statement is correct about how a Layer 2 switch determines how to forward frames? Frame forwarding decisions are based on MAC address and port mappings in the CAM table. Which statement describes a result after multiple Cisco LAN switches are interconnected? The broadcast domain expands to all switches. Match the link state to the interface and protocol status. (Not all options are used.) Picture Match the step to each switch boot sequence description. (Not all options are used.) 1. execute POST2. load the boot loader from ROM3. CPU register initializations4. flash file system initialization5. load the IOS6. transfer switch control to the IOS Refer to the exhibit. How is a frame sent from PCA forwarded to PCC if the MAC address table on switch SW1 is empty? SW1 floods the frame on all ports on SW1, excluding the port through which the frame entered the switch. An administrator is trying to remove configurations from a switch. After using the command erase startup-config and reloading the switch, the administrator finds that VLANs 10 and 100 still exist on the switch. Why were these VLANs not removed? Because these VLANs are stored in a file that is called that is located in flash memory, this file must be manually deleted. Match the description to the correct VLAN type. (Not all options are used.) Pic Refer to the exhibit. A network administrator has connected two switches together using EtherChannel technology. If STP is running, what will be the end result? STP will block one of the redundant links. What is a secure configuration option for remote access to a network device? Configure SSH. Which wireless encryption method is the most secure? WPA2 with AES After attaching four PCs to the switch ports, configuring the SSID and setting authentication properties for a small office network, a technician successfully tests the connectivity of all PCs that are connected to the switch and WLAN. A firewall is then configured on the device prior to connecting it to the Internet. What type of network device includes all of the described features? wireless router Refer to the exhibit. Host A has sent a packet to host B. What will be the source MAC and IP addresses on the packet when it arrives at host B? Source MAC: 00E0.FE91.7799Source IP: 10.1.1.10 Refer to the exhibit. Which static route would an IT technician enter to create a backup route to the 172.16.1.0 network that is only used if the primary RIP learned route fails? ip route 172.16.1.0 255.255.255.0 s0/0/0 121 Refer to the exhibit. In addition to static routes directing traffic to networks 10.10.0.0/16 and 10.20.0.0/16, Router HQ is also configured with the following command: ip route 0.0.0.0 0.0.0.0 serial 0/1/1 Packets with a destination network that is not 10.10.0.0/16 or is not 10.20.0.0/16 or is not a directly connected network will be forwarded to the Internet. What protocol or technology disables redundant paths to eliminate Layer 2 loops? STP Refer to the exhibit. Based on the exhibited configuration and output, why is VLAN 99 missing? because VLAN 99 has not yet been created Which two VTP modes allow for the creation, modification, and deletion of VLANs on the local switch? (Choose two.) transparent, server