Robot 1 (Movement)
I wanted to program moway robots so for this robot I
wanted to program it. I have the start and finish
automatically inserted by the software. All I had to do is
add actions to the robots, these appeared as yellow
rectangles. First I told the robot to go straight for a certain
amount of CM’s and then rotate 90 degrees clockwise. I
copied and paste these instructions because I wanted to
do this cycle twice. Finally to link it up I joined it all up
with actions with the Connector Tool.
This print screen shows me adding the movement action. I
made sure the robot went forwards at a constant speed to a
distance of 10 centimetres. I then saved this.
In this print screen I am telling the robot to turn clockwise 90
degrees and a constant speed. I could also set what part I
wanted the robot to turn from which I chose centre.
I wanted to program moway robots so for this robot I
wanted to program it. I have the start and finish
automatically inserted by the software. All I had to do is
add actions to the robots, these appeared as yellow
rectangles. First I told the robot to go straight for a certain
amount of CM’s and then rotate 90 degrees clockwise. I
copied and paste these instructions because I wanted to
do this cycle twice. Finally to link it up I joined it all up
with actions with the Connector Tool.
This print screen shows me adding the movement action. I
made sure the robot went forwards at a constant speed to a
distance of 10 centimetres. I then saved this.
In this print screen I am telling the robot to turn clockwise 90
degrees and a constant speed. I could also set what part I
wanted the robot to turn from which I chose centre.
