The CFT was designed to evaluate which of the following? - Correct answer-Answer:
Stamina, Agility, Strength
Which equipment is required for a CFT? - Correct answer-Calibrated scale, dummy
grenades, and measuring tape
As a CFT monitor, you must assist in the risk management(RM) process for the CFT.
Which of the following describes the RM process steps? - Correct answer-Identifying
hazards, assessing risks, determining which risks are most important, implementing
controls, and supervising the participants
The CFT monitor is responsible for setting up the events, scoring accurately, using
proper equipment, and __________ - Correct answer-ensuring participants wear the
proper uniform
Which of the following are tasks performed by the CFT monitor during an actual CFT? -
Correct answer-Ensuring proper technique, calling out repetitions.
Location choices for the movement to contact event include outdoor or indoor venue.
What are the minimum location requirements you will need to meet? - Correct answer-
Reasonable level, few to no obstacles
During the maneuver to contact event when may Marines remove uniform blouses? -
Correct answer-With the commander's authorization
As a CFT monitor, you have setup the movement to contact event on an out-and-back
route. The start and finish lines are the same. What is the minimum number of monitors
required for this route? - Correct answer-3
The participant's goal during the movement to contact event is to _______ - Correct
answer-finish as quickly as possible
SSgt Winifred Carter a 28-year-old female, ran the movement to contact event in 3:18.
What is her score for the movement to contact event? - Correct answer-95
What are the equipment requirements for ammunition cans used in the ammunition lift
event? - Correct answer-The contents should not move excessively when lifted, grip
tape applied to the can sides, and use M2A1 5.56mm cans only.
Which of the following are common injuries associated with the ammunition lift event? -
Correct answer-Chipped teeth, black eyes, and broken noses.