Intro to Explosive Safety Management Exam with 100% Correct Answers 2023

Intro to Explosive Safety Management Exam with 100% Correct Answers 2023 Your role is to ensure the safety and serviceability of the stockpile and monitor AE uploads, transportation, and storage activities. Who are you? - Correct answer-QASAS You have been appointed as your installation's safety chief. Who is responsible for developing, implementing, and managing the ESP as part of the overall safety and occupational health program for the installation? - Correct answer-installation commander If you are responsible for assisting commanders and staff with resolving explosives safety concerns, which role do you have? - Correct answer-safety specialist You are assigned to support tactical units regarding execution of ESMP. Who are you? - Correct answer-Ammo Warrant Officer The installation commander assigns one person as the POC for all ESMP activities. Which role does that person fill? - Correct answer-Safety cheif Colonel hires you as the occupational safety and health manager by what reg? - Correct answer-DA PAM 385-64 UXO can be generated - Correct answer-in combat, live fire range, discarded by military munition UXO safety procedures - Correct answer-don't touch, keep away, notify ammo life cycle field - Correct answer-RDT&E, production, storage, ASP, range ammo life cycle theater - Correct answer-port, storage, ASP, AHA, operational units DDESB's mission - Correct answer-create DoD ESP, ESP oversight, advise Secretary of Defense about ESP progress cardinal rule - Correct answer-expose minimumamountof people, minimum amount of explosives, and minimum amount of time after ammo leaves reserve, where does it go next? - Correct answer-ASP what happens to unusable ammo? - Correct answer-demilitarization document check list - Correct answer-DoDD 6055.09E, DoDI 6055.16, AR 385-10, DoDD 6055.09M, DA PAM 385-64 You are working on new ES guidelines for the Army. What key principle should you remember? - Correct answer-service standards can be more restrictive but not less than DoD Where are the minimum level protection regulations found for ES in all services? - Correct answer-DoDD 6055.09M advantages of DU - Correct answer-hard, easy to fabricate, dense, inexpensive, pyro calibers of DU - Correct answer-20mm, 25mm, 30mm, 105mm, 120mm HC 1.1 primary hazard is? - Correct answer-mass detonation what is the primary hazard for mass fire? - Correct answer-1.3 If a vehicle is transporting a load of frag grenades, what signs would it have? - Correct answer-1.2 If a vehicle is transporting a load ammo with fire risk, what signs would it have? - Correct answer-1.4 What are uses for DUs? - Correct answer-aircraft counterweight, kinetic energy projectile, protective armor plating, radiation shield material basic ops inside an ammo magazine - Correct answer-banding and marking basic ops outside an ammo magazine - Correct answer-removing grommets, plugs; air testing; unpacking An organization on your installation is preparing to deploy. Your team must prepare the ammo for them. Which operations are you permitted to do INSIDE a magazine? - Correct answer-inventory, inspecting, shipping You must remove and replace grommets on AE at an ECM. How far from the exterior side of the ECM do you have to perform this task? - Correct answer-50ft You are tasked to unpack, link, and repack SAA at an AGM. How far from the AGM do you have to be to perform this task? - Correct answer-100ft You are inspecting an AGM and the ammo is stacked pretty high. What is the minimum required distance it can be stacked from the ceiling? - Correct answer-18 inches You know the safety office is conducting random inspections of magazines. Which of these ammunition storage guidelines apply? - Correct answer-ammo can't touch walls an exit can't be blocked Ammo encounters electrical energy from - Correct answer-lightening, circuits, static, electromagnetic conductive floors are tested - Correct answer-after installation, renovation, semiannually Dumley just finished reviewing the SOP. How often does he need to inspect conductive flooring? - Correct answer-daily When does Dumley need to test his conductive shoes? - Correct answer-daily, at issue You will be working in the ammo operations area today. Which clothing material should you wear to prevent static? - Correct answer-cotton Which is a common source of static electricity? - Correct answer-steam, air, materials passing through chutes, moving parts controlled burns - Correct answer-100 ft away, building ventilators must be closed, rear vent of ECMs must be covered, hoses ready You need to ensure there are firebreaks around your AGMs. What is the minimum distance the firebreak must be from each AGM? - Correct answer-50ft While clearing a magazine for fire prevention you notice there are no fire extinguishers in any of the magazines. How many hazard-specific fire extinguishers must be readily accessible where ammo is being handled? - Correct answer-2 You are scheduling a controlled burn to prevent fires. This activity must be located at least how many feet away from an open storage area or building handling ammunition? - Correct answer-100ft You are inspecting a magazine and it has no fire symbols. You know the DODIC has the abbreviation BBC beside it. Which Fire Symbols should be on the magazine? - Correct answer-symbol 1 set 2 You must inspect several operating buildings. Which of these is a requirement for operating building exits? - Correct answer-self closing doors that swing outward You are working on a protective construction design. All of these are considerations you must make for AE storage and operating buildings EXCEPT - Correct answer-container locks