CDC 2w051 set B| 251 QUESTIONS| WITH COMPLETE SOLUTIONS

Before using an electrical drill, what is the first thing you should do? CORRECT ANSWERS: Make sure the diameter of the hole to be drilled is within the capacity of the drill. The purpose of cutting lubricant in most drilling operations is to increase the CORRECT ANSWERS: drilling speed and the drill bit life which minimum articles of safety gear must be worn when using a bench grinder CORRECT ANSWERS: Eye and Face protection An Electrical saw blade must be operating at what speed before it contacts the material being cut? CORRECT ANSWERS: Full How many pounds per square inch (psi) of clean, dry air is required at the tool end of the air hose to ensure the tool is operating safely and efficiently? CORRECT ANSWERS: 90 What condition would prevent an operator rom applying power to a hoist or other powered lifting device? CORRECT ANSWERS: An AF Form 979 is attached to the unit. What should be worn anytime there is a potential for injury from overhead objects during a lifting operation. CORRECT ANSWERS: Protective helmets What is the most common type of lifting sling used in the munitions career field? CORRECT ANSWERS: Wire rope The following are all good safety practices to follow when using a lifting sling except CORRECT ANSWERS: inspecting the sling by passing your bare hand over the body of the sling The annunciators displayed on the Fluke 8025 series millimeter are used to distinguish among. CORRECT ANSWERS: Ohms, Kilohms, and megohms What are the two operational modes of the Fluke 8025-series multimeter? CORRECT ANSWERS: Range and hold The sterring system on the MHU-141/M trailer has a turning radius of how many inches? CORRECT ANSWERS: 200 When the MHU-141 trailer is loaded or towed with the hinged deck open, what must be done? CORRECT ANSWERS: The deck-panel supports must be properly positioned and locked in place with quick-release pins. What is the maximum load capacity of the MHU-110