CISCO 2 Module 8 Quiz SLAAC and DHCPv6 Questions and Answers (Graded A+) 2024

It sends an ICMPv6 Neighbor Solicitation message with the IPv6 address as the target IPv6 address. - Correct answer-How does an IPv6 client ensure that it has a unique address after it configures its IPv6 address using the SLAAC allocation method? Router advertisements that are received from the link router - Correct answer-Which method would an IPv6-enabled host using SLAAC employ to learn the address of the default gateway? random generation and EUI-64 - Correct answer-What two methods can be used to generate an interface ID by an IPv6 host that is using SLAAC? (Choose two.) It must send an ICMPv6 Neighbor Solicitation message to ensure that the address is not already in use on the network. - Correct answer-A client is using SLAAC to obtain an IPv6 address for its interface. After an address has been generated and applied to the interface, what must the client do before it can begin to use this IPv6 address? ipv6 address dhcp - Correct answer-Which command should be configured on a router interface to set the router as a stateful DHCPv6 client? the ICMPv6 Router Advertisement - Correct answer-What message informs IPv6 enabled interfaces to use stateful DHCPv6 for obtaining an IPv6 address? FF02::2 - Correct answer-Which destination IP address is used when an IPv6 host sends a DHCPv6 SOLICIT message to locate a DHCPv6 server? SLAAC - Correct answer-In which alternative to DHCPv6 does a router dynamically provide IPv6 configuration information to hosts? DCHPv6 Information-Request - Correct answer-A company implements the stateless DHCPv6 method for configuring IPv6 addresses on employee workstations. After a workstation receives messages from multiple DHCPv6 servers to indicate their availability for DHCPv6 service, which message does it send to a server for configuration information? DAD - Correct answer-What process is used in ICMPv6 for a host to verify that an IPv6 address is unique before configuring it on an interface? IPv6 addressing is dynamically assigned to clients through the use of ICMPv6 The default gateway of an IPv6 client on a LAN will be the link-local address of the router interface attached to the LAN - Correct answer-What are two characteristics of the SLAAC method for IPv6 address configuration? (Choose two.)IP The client should automatically configure an IPv6 address and then contact a DHCPv6 sever for more information. - Correct answer-After booting, a client receives an ICMPv6 RA message with the M flag set to 0 and the O flag set to 1. What does this indicate? it is required for sending ICMPv6 RA messages - Correct answer-A network administrator is entering the command ipv6 unicast-routing to start configuring DHCPv6 operation on a router. Which statement describes the function of this command?