Pipe Fitters Test Bank Exam Latest Update |Complete Questions & Correct Detailed Answers Verified 100% Graded A+

Pipe Fitters Test Bank Exam 2026 -2027\Latest
Update |Complete Questions & Correct Detailed
Answers \Verified 100% Graded A+




What is the length of pipe required to fabricate a 6" diameter schedule 40
pipe spool with one class 150# RFWN flange on one end, and one class
300# RFWN flange on the other end, with a face-to-face measurement of 18
1/2" (assume a 1/8 welder gap)


ANSWERS: 10 7/8


What is the standard torquing valve of the Victualic coupling bolts?


ANSWERS: NO torquing is required


At what dimension does a pipe begin to be measured by the outside
diameter?


ANSWERS: 14 inches

What is the 4th ordinate cutback measurement for a 3" diameter type 3
dummy leg on a 6" elbow


ANSWERS: 10 3/16

,What is the ratio of the distance that the ladder should be from the base
of the wall to the height where the ladder meets the wall.


ANSWERS: 1/4


Trenches MUST be designed, excavated, and shored according to


ANSWERS: OSHA standards


angles of any triangle add up to


ANSWERS: 180º


What is the travel on a rolling offset that has a Run of 18", a roll 24" and
height of 12"?


ANSWERS: 34 15/16


Which of the following is a quick opening


valve? Globe, Needle , Butterfly , Gate ?


ANSWERS: Butterfly


Find the lowest common denominator for 1/8 and 1/2


ANSWERS: 8

, A piping drawing that shows both side view and top view of a piping system is


ANSWERS: isometric


the movement of pipe that is caused by an increase in temperature is called


ANSWERS: Thermal expansion


A cold spring relieves..

ANSWERS:
Thermal expansion


How many feet apart must oxygen and fuel gas cylinders be stored,
unless the is a 5 ft high, 30 minute burn rated wall between them?


ANSWERS: 20


When performing a line break, first?


ANSWERS: break the bolts down & away from you


A pipe nipple is any length of threaded pipe that is shorter than..


ANSWERS: 12"