Solution Manual and Answer Guide Electrical Wiring Commercial 18th Edition by Phil Simmons, Ray C. Mullin, Mark Ode| 9780357767108| All Chapters 1-21| LATEST

Solution Manual for Electrical Wiring Commercial, 18th
vb vb vb vb vb vb




Edition by Phil Simmons
vb vb vb vb




All Chapters Covered 1-21| Verified Questions & accurate
v b vb vb vb vb vb v b




Solutions for Exam Preparations| A+ GRADED
v b vb v b v b v b v b v b




1 | P a

,2 | P a

,Solution and Answer Guide

C HAPTER 1: V B COMMERCIAL BUILDING PLANS AND SPECIFICATIONS


TABLE OF CONTENTS

Review ...................................................................................................................................................... 1



Note to instructor:
vb v b v b It is recommended that students be required to respond,
v b v b v b v b v b v b v b v b


where appropriate,
v b vb v b with answers that are complete
v bsentences. v b v b v b v b




REVIEW

Refer to the vb v b v b National Electrical Code or the working drawings when
v b v b vb vb v b v b v b


necessary.
v b v b Where applicable, responses
vbshould be written in v b v b v b v b v b


complete
v b v b sentences.

1. What section of a commercial v b v b building’s specification v b contains a
list of contract
vb documents?
vb v b




Answer: A list of the contract documents is contained in
General Clauses and Conditions. A listing of the Commercial
Building contract documents is presented in this chapter under the
h eading ―Commercial Buil ding Plans.‖ The instructor may wish to have the
students check over this listing and compare it with the
plans provided.
2. The requirement for temporary
v b light and power at the job site v b v b v b v b v b v b v b v b v b v b will
v beb found in what portion of a commercial building’s specification?
v b v b v b vb v b v b v b v b v b




Answer: The Supplementary v General
b Conditions specifies
v b the v b v b v b v b


job v site requirements
b v b for temporary vb light and power. In v b v b v b v b v b v b


somev b contracts, this v b v b


electrical system becomes the v responsibility
b of the general v b v b v b v b v b v b


contractor; in other contracts,
v b it is v the belectrical contractor’s
v b vb v b v b v b v b v b


responsibility to install
v b and maintain the temporary electrical v b v b v b v b vb v b v b


system. The
v b instructor may wish
v b to refer the
v b student to v b v b v b v b v b v b vb


NEC
v bArticle 590 vand discuss
b the requirements in v detail.
b v b v b v b v b v b v b




3 | P a

, 3. The v b electrician v b uses v b the v b Schedule v b of v b Working v b Drawings v b for what v b


purpose?
v b




Answer: The electrician uses the Schedule of Working Drawings v b


to determine whether
v b vb all of the drawings are at hand. v b v b v b v b v b v b v b


The
v binformation on v b v b


―the other sheets‖
v b may be very important,
v b especially in v b v b v b v b v b v b


v coordinating
b with other contractors. v b vb v b




4. Complete the following items by indicating the letter(s)
v b v b v b v b v b v b v b


designating the correct
v b source(s) of information:
v b vb v b v b v b




No. Answer Item Information

4. Sections Ceiling v b height Sections, Sheet A6

5. Electrical Electrical Electrical symbol schedule, v b v b


symbo
vb receptacle
vb Chapter 2,
v b Figure 2–6 vb v b


l style
v b


schedu
vb


l
e

6. Electrical Electrical Electrical layout drawings, vb v b


layout
vb outlet
vb Sheets El,
vb E2, and vb v b v b v b E3
drawin
vb location
vb


gs
v b




7. Elevations Exterior wall v b v b finishes Elevations, Sheets A4 and A5

8. Site plan Grading v b v b elevations Site plan, Sheet A4

9. Electrical Panelboard schedules Electrical layout drawings, Sheet E4
layout
vb


drawin
vb


gs
v b




10. Architectural Room v b width Architectural floor vb v b plan, Sheets
v b


floor vb Al, A2,
v b and vb v b v b A3
plan v b




11. Architectural Swing of door Architectural floor v b v b plan, v b Sheets v b Al, v b A2,
floor vb and A3 v b


plan v b




4 | P a