100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.6 TrustPilot
logo-home
Exam (elaborations)

STATIONARY ENGINEER COMPREHENSIVE EXAM UPDATED QUESTIONS AND SOLUTIONS RATED A+

Rating
-
Sold
-
Pages
9
Grade
A+
Uploaded on
02-01-2026
Written in
2025/2026

STATIONARY ENGINEER COMPREHENSIVE EXAM UPDATED QUESTIONS AND SOLUTIONS RATED A+

Institution
Stationary Engineer
Course
Stationary engineer









Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
Stationary engineer
Course
Stationary engineer

Document information

Uploaded on
January 2, 2026
Number of pages
9
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

STATIONARY ENGINEER COMPREHENSIVE EXAM UPDATED
QUESTIONS AND SOLUTIONS RATED A+
✔✔CONTINUOUS BLOWDOWN - ✔✔The uninterrupted removal of concentrated boiler
water from a boiler to control total solids concentration in the remaining water.

✔✔CONTROL VALVE - ✔✔A valve used to control the flow of air, gas, water, steam or
other substance.

✔✔DAMPER - ✔✔- A device for introducing a variable pressure drop in a system used
for regulating the volumetric flow of a gas, such as air.

✔✔DEAERATION - ✔✔Removal of air and gases from boiler feed water prior to its
introduction to a boiler.

✔✔DOWNCOMER - ✔✔A tube or pipe in a boiler or waterwall circulating system
through which fluid flows downward.

✔✔DRAFT - ✔✔The difference between atmospheric pressure and some lower
pressure existing in the furnace stack or gas passages of a steam generating unit.

✔✔DRY STEAM - ✔✔Steam containing no moisture. Commercially dry steam
containing not more than one half of one percent moisture.

✔✔ECONOMIZER - ✔✔Utilizes waste heat by transferring heat from flue gases to
warm incoming feedwater.

✔✔ELECTROSTATIC PRECIPITATOR - ✔✔A device for collecting dust, mist or fume
from a gas stream, by placing an electrical charge on the particle and removing that
particle onto a collecting electrode.

✔✔EXPANSION JOINT - ✔✔The joint to permit movement due to expansion without
undue stress.

✔✔FEED PUMP - ✔✔A pump that supplies water to a boiler.

✔✔FEEDWATER - ✔✔Water introduced into a boiler during operation. It includes
make-up and return condensate.

✔✔FIRING RATE CONTROL - ✔✔A pressure temperature or flow controller which
controls the firing rate of a burner according to the deviation from pressure or
temperature set point. The system may be arranged to operate the burner on-off, high-
low or in proportion to load demand.

, ✔✔FLAME DETECTOR - ✔✔A device which indicates if a fuel (liquid, gaseous, or
pulverized) is burning, or if ignition has been lost. The indication may be transmitted to a
signal or to a control system.

✔✔FLASHING - ✔✔The process of producing steam by discharging water into a region
of pressure lower than the saturation pressure that corresponds to the water
temperature

✔✔FLUE - ✔✔A passage for products of combustion.

✔✔FLASH POINT - ✔✔The lowest temperature at which, under specified conditions,
fuel oil gives off enough vapor to flash into a momentary flame when ignited.

✔✔FOAMING - ✔✔The continuous formation of bubbles which have sufficiently high
surface tension to remain as bubbles beyond the disengaging surface.

✔✔ABT - ✔✔Automatic Bus Transfer, utility to UPS

✔✔Air Ejector - ✔✔Type of Jet Pump used to remove air and other gases from a
condenser

✔✔Air Register - ✔✔Device in the casing of a boiler, used for regulating the amount of
air for combustion and to provide a circular motion of air.

✔✔Alloy - ✔✔Mixture of 2 or more metals

✔✔Ammeter - ✔✔Instrument for measuring rate of flow of electrical current in amperes

✔✔Annealing - ✔✔Softening of metal by heating and slow cooloing

✔✔Automatic Combustion Control System (ACC) - ✔✔A system that provides a means
for automatically controlling fuel and air mixture

✔✔Back Pressure - ✔✔Pressure exerted on the exhaust side of a pump or engine

✔✔BDC - ✔✔Bottom Dead Center

✔✔Boiler Design Pressure - ✔✔Pressure specified by OEM, usually about 103% of
normal steam drum operation pressure

✔✔Boiler internal fittings - ✔✔Parts in side of the boiler which control steam and water

✔✔Boiler operating Pressure - ✔✔Pressure required to be maintained in a boiler while
in service

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
BOARDWALK Havard School
View profile
Follow You need to be logged in order to follow users or courses
Sold
182
Member since
1 year
Number of followers
7
Documents
24136
Last sold
4 days ago
BOARDWALK ACADEMY

Ace Your Exams With Top Quality study Notes And Paper✅✅ ALL ACADEMIC MATERIALS AVAILABLE WITH US✅✅ LEAVE A REVIEW SO THAT WE CAN LOOK AND IMPROVE OUR MATERIALS.✅✅ WE ARE ALWAYS ONLINE AND AVAILABLE DONT HESITATE TO CONTACT US FOR SYUDY GUIDES!!✅✅ EVERYTHING IS GRADED A+✅✅ COLOUR YOUR GRADES WITH US , WE ARE HERE TO HELP YOU DONT BE RELACTANT TO REACH US

3.7

33 reviews

5
14
4
6
3
7
2
0
1
6

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions