Pipe Fitter Test | | 40 Questions with 100% Correct Answers | Updated & Verified

Pipe Fitter Test | | 40 Questions with 100% Correct Answers | Updated & Verified the 2 most commonly used types of tubing connections are compression and flared. - ANSWER -true a pressure indicator is indicated by a Pi symbol on a flow chart - ANSWER -true a pressure indicator is indicated by a PI symbol on a flow chart - ANSWER -true spray painting or modifying hard hats may damage them - ANSWER -true pipe stamped with 316L and 304L denotes a grade or type of a carbon steel pipe and fittings. - ANSWER -false flange insulators Kits are installed for a cathodic protection - ANSWER -true the proper way to lift is bend at your knees and let you legs do the lifting - ANSWER -true exposure to high level noises can be controlled - ANSWER -true to reduce chances of heat stress you should drink plenty of beet and alcohol - ANSWER -false a temperature indicator is indicated by a TI symbol on a flow chart - ANSWER true What does TE in TE-601 stand for? - ANSWER -temperature element what does B.T.U stand for? - ANSWER -British Thermal Unit what is the boiling point of water? - ANSWER -212*F What is 3.1416? - ANSWER -Pi what is the circumference of a 15" pipe? (to the nearest tenth0 - ANSWER -47" 4" in the hundredths of a foot is? - ANSWER -.33 what is the take off for a 4" x 3" LR reducing 90* ell? - ANSWER -6" on isometric drawings what does RFWN mean? - ANSWER -raised face weld neck what does the Pi in Pi-209 stand for? - ANSWER -pressure indicator 101.25' converted into inches is what? - ANSWER -101'-3" if testing the shell side of an exchanger with the flat cap removed and all the tubes on the bottom row had a steady flow of water pouring out of them, this would indicate: - ANSWER -floating head gasket leaking 3/4" is equal to? - ANSWER -6/8 the lap joint flange is usually used when_______? - ANSWER -flange hold alignment is a problem what is the number of a square feet in the surface of a steel plate 180 inches high and 48 inches wide? - ANSWER -60 square feet what device is installed between a control valve and the air supply header? - ANSWER -regulator what is the most common degree of bevel on a pipe to be butt welded? - ANSWER -37 1/2 the three states of matter are: - ANSWER -solids, liquids,and gases what is the circumference of a circle that has a 20.50 inch diameter? - ANSWER 64.37 extension lines should: - ANSWER -always touch the object being drawn what is 23% of 1598? - ANSWER -367.54 what is the circumference of a circle with a diameter of 5" - ANSWER -15.70" what is the area of a triangle that is 30.5 feet long and 15 feet wide? (A=WxL) - ANSWER -457.5 square feet