Terms in this set (81)
After application of 10%, 0.5 degrees
the load, but before
reaching _____ of
the anticipated
specimen strength,
check to see that
the axis of the
cylinder does not
depart from vertical
by more than _____.
A higher rate of True
loading shall be
permitted during
the application of
the first half of the
anticipated loading
phase. True or
False?
Align the _____ of Axis, center
the specimen with
the _____ of thrust
of the spherically
seated block.
Apply the load ____ Continuously, shock
and without ____.
,A slight twisting Excess paste, voids
action will help
eliminate _____ and
air _____ when the
capping plate is
placed onto the
mound of the paste.
Bearing blocks used Third-point loading
in the _____ method
must ensure that
forces applied to
the beam will be
perpendicular to the
face of the
specimen and
applied without
eccentricity.
Calculate the Maximum load, cross-sectional
compressive
strength by dividing
the _____ by the
average _____ area
determined.
Depressions in the .20 in.
ends of the
cylinders that
exceed ____ must be
corrected by sawing
or grinding prior to
testing.
, Discard the test b)
results when the
fracture occurs in
which of these
instances:
a) outside the
middle third of the
span length but by
less than 5% of the
span length.
b) outside the
middle third of the
span length by more
the 5% of the span
length
c) within the middle
third of the span
length
During the testing, Use of shims, grinding, capping
if suitable contact is
not made between
the specimen and
bearing block
surfaces, _____,
_____ or _____ may
be required.
After application of 10%, 0.5 degrees
the load, but before
reaching _____ of
the anticipated
specimen strength,
check to see that
the axis of the
cylinder does not
depart from vertical
by more than _____.
A higher rate of True
loading shall be
permitted during
the application of
the first half of the
anticipated loading
phase. True or
False?
Align the _____ of Axis, center
the specimen with
the _____ of thrust
of the spherically
seated block.
Apply the load ____ Continuously, shock
and without ____.
,A slight twisting Excess paste, voids
action will help
eliminate _____ and
air _____ when the
capping plate is
placed onto the
mound of the paste.
Bearing blocks used Third-point loading
in the _____ method
must ensure that
forces applied to
the beam will be
perpendicular to the
face of the
specimen and
applied without
eccentricity.
Calculate the Maximum load, cross-sectional
compressive
strength by dividing
the _____ by the
average _____ area
determined.
Depressions in the .20 in.
ends of the
cylinders that
exceed ____ must be
corrected by sawing
or grinding prior to
testing.
, Discard the test b)
results when the
fracture occurs in
which of these
instances:
a) outside the
middle third of the
span length but by
less than 5% of the
span length.
b) outside the
middle third of the
span length by more
the 5% of the span
length
c) within the middle
third of the span
length
During the testing, Use of shims, grinding, capping
if suitable contact is
not made between
the specimen and
bearing block
surfaces, _____,
_____ or _____ may
be required.
