Complete Questions and Guide Answers
100% Verified Graded A+
1. The reading on the micrometer shown above is ?
Answer: 6.5mm
2. What causes brake pulsation?
Answer: Variation thickness of brake rotor
3. A wheel bearing can cause a DSC fault. True or False?
Answer: True
4. 3 wheel shows 24 miles and 1 is 23, what can be the cause?
Answer: Bad wheel bearing
5. In a parallel circuit it shows three bulbs that aren't operating. What can be the cause ?
Answer: Open from Y TO Z
6. An XDrive vehicle equipped with a transfer case makes a clunking noise during
accelerating and braking. What could be the cause?
Answer: Loose Chain
, 7. A vehicle comes in with a faulty differential. The fluid is overfilled and creamy, what could
be the cause?
Answer: Waterinthefluid
8. A vehicle comes in with a concern of a clunking sound from the rear during a braking
and accelerating. What is the most likely cause?
Answer: Thrust Arm
9. A circuit shows a radio that is inoperative on the power outlet side. What could be the
cause?
Answer: Bad Fuse
10. A circuit shows the horn is inoperative. What could be the cause?
Answer: High resistance on the clock spring
11. A vehicle has an overheated left front rotor during driving. What could be the cause?
Answer: Seized front left caliper piston
12. DCS equipped vehicles use a system to choke or drop the RPM in the engine. True or
false?
Answer: True
13. On a DSC equipped vehicle, Technician A says it receives inputs from the steering
angle sensor. Technician B says it receives inputs from the brake switch.