NEIEP 800 Final Review 2025: Advanced Specialist Practice & Curriculum Design

Page 1 of 162


NEIEP 800 FINAL EXAMS (LATEST 2025 UPDATES

STUDY BUNDLE WITH COMPLETE SOLUTIONS)

QUESTIONS AND VERIFIED ANSWERS | 100%

CORRECT | GRADE A

Hydro elevators in low rise applications do not need an _____

_____ room. .....ANSWER.....overhead machine

Some advantages of hydros are lower equipment and building

construction costs because the load of a hydro is carried to the

_____ where as the load of a traction car is carried by the

_____ _____. .....ANSWER.....ground, building structure

When drilling the jack hole, the only proper way to determine if

the hole is plumb is to remove the drill stem and bit and use a

_____ _____. .....ANSWER.....Spider Bob

,Page 2 of 162


To plumb the hole, a spider bob is attached to a length of piano

wire suspended from as near as possible to the top of the _____

or from a fixed point on the drill rig. .....ANSWER.....Hoistway

When welding a joint, lay _____ inch tack welds _____ degrees

apart, shift it 90 degrees and lay two more 1 inch tack welds

180 degrees apart. .....ANSWER.....1, 180

On power units having the motor beneath the tank, the pump

may be either _____ driven or _____ coupled.

.....ANSWER.....belt, direct

The purpose of the _____/_____ is to silence the effect of any

pulsations in the pump output and should be as close to the pump

as possible. .....ANSWER.....silencer, muffler

On Bolsters/Bolster Assembly, the plunger is fastened to the

_____ _____ which is then mounted to the center of the Bolster

Assembly. .....ANSWER.....platen plate

,Page 3 of 162


With wye-delta, reduced current starting is accomplished without

the need for _____. .....ANSWER.....resistors

_____ run buttons should run the platform and sling at leveling

speeds only. .....ANSWER.....Temporary

A _____ _____ consists of a piston held closed by an adjustable

spring and must open at a certain pressure to prevent any

further increase in pressure. .....ANSWER.....relief valve

A _____ lowering valve allows the car to be lowered at a speed

not exceeding 20fpm in case of power failure.

.....ANSWER.....manual

As the oil temperature changes, the _____ will change as well

and will effect the performance, more specifically, the leveling

and approach of the elevator. .....ANSWER.....viscosity

Be sure wellways are properly _____ to avoid accidental injury

to you, your team or anyone working outside of our industry.

.....ANSWER.....barricaded

, Page 4 of 162


Barricades around the wellway must be _____ inches high and

be capable of withstanding a _____lb force. .....ANSWER.....42,

200

A _____ protects you if you come in contact with a hot wire or

component and then come in contact with ground. It opens the

circuit and diverts the supplied current to ground.

.....ANSWER.....GFCI

A _____ _____ is useful for horizontal (side-to-side) pulling of

the truss while being lowered into the wellway.

.....ANSWER.....lever hoist

Code specifies the use of anti-slide devices if the outer edge of

the deck is greater than _____ inches from the center line of the

handrail. .....ANSWER.....12

(True/False) Anti-slide devices must be less than 3/4" in height,

have no sharp corners or edges and fastened to the deck no