IAAI CFI Exam/IAAI CFI Practice Exam
Newest 2025 Complete Questions And
Correct Answers (Verified Answers) |Already
Graded A+||Brand New!!
absolute temperature - . . ANSWER ✔ ✔Temperature
measured in Kelvins or Rankines.
Accelerant - . . ANSWER ✔ ✔A fuel or oxidizer, often an
ignitible liquid, intentionally used to initiate a fire or
increase the rate of growth or spread of fire.
accident - . . ANSWER ✔ ✔An unplanned event that
interrupts an activity and sometimes causes injury or
damage or a chance occurrence arising from unknown
causes; an unexpected happening due to carelessness,
ignorance and the like.
Active Fire Protection System - . . ANSWER ✔ ✔A system
that uses moving mechanical or electrical parts to achieve
a fire protection goal.
,2|Page
ambient - . . ANSWER ✔ ✔Someone's or something's
surroundings, especially as they pertain to the local
environment; for example, ambient air and ambient
temperature.
Ampacity - . . ANSWER ✔ ✔The maximum current, in
amperes, that a conductor can carry continuously under
the conditions of use without exceeding its temperature
rating.
Ampere - . . ANSWER ✔ ✔The unit of electric current that
is equivalent to a flow of one coulomb per second
Arc - . . ANSWER ✔ ✔High-temperature luminous electric
discharge across a gap or through a medium such as
charred insulation.
Arc Mapping - . . ANSWER ✔ ✔The systematic evaluation
of the electrical circuit configuration, spatial relationship
of the circuit components, and identification of electrical
arc sites to assist in the identification of the area of origin
and analysis of the fire's spread.
,3|Page
Arc - . . ANSWER ✔ ✔
Combustible Liquid - . . ANSWER ✔ ✔A liquid with a
flash point ABOVE 100F
Current Flow - . . ANSWER ✔ ✔If the current flowing out
from an electrical panel is 12.5 amps, and it then flows
through an electrical load of 1500 watts, what is the
amperage of the remaining current flow of the return
circuit?
Power (P) - . . ANSWER ✔ ✔Power (P) = current (I) x
voltage (V)
Watts - . . ANSWER ✔ ✔Watts = amps x volts
Year of NFPA 1033 First Edition - . . ANSWER ✔ ✔1987
Recommended Distance for Securing Blast Scene - . .
ANSWER ✔ ✔1.5 times the distance from the furthest
debris
, 4|Page
Onset of Flashover Temperature - . . ANSWER ✔ ✔1100°F
Copper Melting Temperature - . . ANSWER ✔ ✔1960°F
Radiant Heat Flux Measurement - . . ANSWER ✔ ✔2
W/cm2 indicates the onset of flashover
Voltage at Service Entrance Cables - . . ANSWER ✔ ✔240
volts between the two hot wires in most single-family
residences in the United States
NFPA 921 Revision Cycle - . . ANSWER ✔ ✔3 years
Flash Point of Power Steering Fluid - . . ANSWER ✔
✔350°F
Typical Pressure in High-Pressure Fuel-Injected Vehicles -
. . ANSWER ✔ ✔35-70 p.s.i.
Lower and Upper Explosive Limit of Natural Gas - . .
ANSWER ✔ ✔5 and 17