Med Gas Study Guide| Actual Exam Questions and 100% Correct Answers| Latest Update

Med Gas Study Guide| Actual Exam Questions and 100% Correct Answers| Latest Update When is the initial pressure test conducted, by a medical gas installer, on a nitrous oxide system? After blowdown of a distribution piping In those portions of systems intended to handle oxygen at pressures greater than 350 psi the interconnecting hose shall NOT contain ________ materials? Polymeric In a Category 1 Dental and Gas Vacuum Piping system, which of the following is an NFPA 99 requirement for the labeling of pipes? Color coding & non-standard pressure Which of the following treatments shall be performed before brazing cut ends of a tube to be installed in a medical gas piping system? Cut ends shall be rolled smooth or deburred Manifolds for gas cylinders shall actuate a(an) _______ signal and shall activate an indicator at all _______ alarm panels to indicate when or just before changeover from one header to the other. Local, master In a non-anesthetizing area, on which side of a zone valve shall the pressure/vacuum sensor be located? Station outlet/inlet What is the purpose of using an oxygen analyzer during the piping purge prior to brazing? Assure that all ambient air has been removed from the pipeline A medical gas master or area alarm panel shall be set to actuate a(an) _____ indicator when the communication with an alarm-initiating device is disconnected. Audible and visual When an EOSC becomes the temporary supply source, a facility will monitor the system by use of which of the following? Providing four connection points to both master alarms Which of the following conditions must be met where medical gas and vacuum systems are installed by non-certified personnel?