Oil Burner's Test Exam | 1-200 Questions With 100% Correct Answers | Latest Updates | 2025/2026

Oil Burner's Test Exam | 1-200 Questions With 100% Correct Answers | Latest Updates | 2025/2026 In an electric circuit for the wattage to remain the same if the voltage drops, the amperage must - answer-Increase Atomizing type burners were designed to burn which type of fuel - answer-Type 2 fuel oil Pour point problems with outside above ground fuel tanks can be partially relieved by - answerReducing the pour point of No. 2 fuel oil by blending it with No. 1 fuel oil. A fuel oil storage tank cannot be installed - answer-In the furnace room with 5' of heating unit. The primary purpose of a fuel pump on a high-pressure burner is to - answer-Deliver oil at a constant and regulated pressure to the nozzle If the vacuum reading is substantially above the calculated reading, (with the burner running) the cause may be - answer-Plugged fuel filter, Kinked oil supply line, Check valve sticking With most new flame retention burners, the motor speed is - answer-3450 To check for proper nozzle line cut-off, the pressure gauge is installed in the - answer-Nozzle Port Fuel units are generally set at the factory at - answer-100psiThe oil burner nozzle in a high-pressure burner performs the following functions - answer-Atomizes the oil Provides a pattern of oil spray Delivers a fixed amount of oil The nozzle flow rate, spray angle and pattern are directly related to - answer-•Tangential slots . Swirl chamber Orifice Cold oil or high viscosity problems may be eliminated by - answer-•Increasing pump pressure and reducing nozzle size • Installing a nozzle line pre-heater