Questions with Accurate Answers
A controller may issue a safety alert to an aircraft under his control when that
aircraft is correct answer unsafe proximity to terrain, obstructions, or another
aircraft.
A large letter "X" placed near the runway threshold indicates the correct answer
runway is closed
A power loss occurs when you apply carburetor heat because correct answer less
dense air is entering the engine.
According to the markings on the accompanying airspeed indicator, what is the
maximum speed with flaps fully extended? correct answer 85 knots (white arc)
After departing runway 36, you make a left turn to a heading of 180º. If the
magnetic compass initially indicates a turn in the opposite direction, you should
know that this reaction is correct answer normal for all magnetic compasses
under similar conditions. (magnetic dip)
An airport beacon with two white flashes and one green flash indicates correct
answer a military airport
Assume that you land at an airport with the altimeter set to 29.92 instead of the
current setting of 30.00. What will the altimeter read if the field elevation is 2,000
feet MSL? correct answer 2,080 feet MSL (10 feet per .01 in. Hg.)
, At nontower airports without an FSS or UNICOM, the CTAF usually is correct
answer 122.9 MHz.
Detonation can be described as correct answer fuel in the cylinders exploding
instead of burning smoothly.
Dihedral is used to stabilize the airplane about the correct answer longitudinal
axis.
Except when necessary for takeoff and landing, when you fly over congested
areas, you must maintain an altitude of at least 1,000 feet... correct answer above
the highest obstacle within a horizontal distance of 2,000 feet of the aircraft.
Excessive cylinder head and engine oil temperatures can be caused by correct
answer using a lower-than-normal fuel grade.
FAA Advisory Circulars provide what type of information? correct answer
Nonregulatory, but necessary for good operating practices
How are the lift and drag components of the wing affected when you lower the
flaps? correct answer Both lift and drag increase
How often should you check the heading indicator and align it with the magnetic
compass? correct answer Every 15 minutes
If the engine magneto switch is turned to the "OFF" position, but the engine
continues to run, the probable cause is correct answer a broken magneto ground
wire.