ASE G1 EXAM QUESTIONS WITH
REVIEWED CORRECT
ANSWERS
A disc brake caliper does not move and one of the pads is worn more than the other.
What is the most likely cause? - Answer-The caliper sides are likely to be stuck
To measure the voltage drop in an electrical circuit using a DMM, what position should
the meter be set to? - Answer-DCV
Technician A says that memory functions can be kept when disconnecting a battery by
connecting a "memory saver" to the lighter plug on many vehicles. Technician B says
that memory functions can be kept when disconnecting a battery by connecting a
"memory saver" to the 16-pin diagnostic link connector (DLC) on 1996 and newer
vehicles. Which technician is correct? - Answer-Both A and B
A light bulb is being tested using an ohmmeter and it reads 0.5 ohms between the two
terminals of the bulb. This measurement indicates ______________. - Answer-Normal
resistance
A starter is being replaced. What precautions are needed before performing this
procedure? - Answer-Disconnect the negative battery cable
The voltage drop is being tested on the positive (power) side of a cranking circuit.
Technician A says that the voltmeter test leads need to be placed at the battery positive
and the other test lead to the battery stud of the starter to measure the voltage drop on
the positive part of the circuit. Technician B says that the engine has to be cranked
using the starter to measure the voltage drop. Which technician is correct? - Answer-
Both A and B
How can the blend and mode door be checked for proper operation? - Answer-All of the
above:
Start the engine and select heat mode
Switch between heat and AC and check to see that the airflow moves from the floor to
the dash vents
Switch from AC to defrost to check to see that the airflow moves from the floor to the
dash vents
REVIEWED CORRECT
ANSWERS
A disc brake caliper does not move and one of the pads is worn more than the other.
What is the most likely cause? - Answer-The caliper sides are likely to be stuck
To measure the voltage drop in an electrical circuit using a DMM, what position should
the meter be set to? - Answer-DCV
Technician A says that memory functions can be kept when disconnecting a battery by
connecting a "memory saver" to the lighter plug on many vehicles. Technician B says
that memory functions can be kept when disconnecting a battery by connecting a
"memory saver" to the 16-pin diagnostic link connector (DLC) on 1996 and newer
vehicles. Which technician is correct? - Answer-Both A and B
A light bulb is being tested using an ohmmeter and it reads 0.5 ohms between the two
terminals of the bulb. This measurement indicates ______________. - Answer-Normal
resistance
A starter is being replaced. What precautions are needed before performing this
procedure? - Answer-Disconnect the negative battery cable
The voltage drop is being tested on the positive (power) side of a cranking circuit.
Technician A says that the voltmeter test leads need to be placed at the battery positive
and the other test lead to the battery stud of the starter to measure the voltage drop on
the positive part of the circuit. Technician B says that the engine has to be cranked
using the starter to measure the voltage drop. Which technician is correct? - Answer-
Both A and B
How can the blend and mode door be checked for proper operation? - Answer-All of the
above:
Start the engine and select heat mode
Switch between heat and AC and check to see that the airflow moves from the floor to
the dash vents
Switch from AC to defrost to check to see that the airflow moves from the floor to the
dash vents
