Residential Contractor (2025) EXAM
QUESTIONS AND ALL CORRECT
ANSWERS 100% SOLVED AND
GUARANTEED SUCCESS!!
What are masonry exterior non-load bearing walls that are not wholly supported
at each story? - (answers)Curtain Walls
Buildings shall have an attic access where attic areas exceed 30 sq feet and have a
vertical height of - (answers)30" or greater
The best piece of equipment to strip material over a long distance is a -
(answers)Scraper
The effect of loading uphill using a scraper is: - (answers)It increases cycle time
A building slab will be 25' x 90' x 8" How many cubic yards of concrete will be
needed? (Note: assume that the grade will be perfectly level and that there will
be no crown or slope in the slab do not include waste or accessing your estimate.
- (answers)56 yd
Block or stack bond is purely a _________ bond - (answers)Pattern
How much do concrete tiles weigh per square? - (answers)900 lbs
,For acceptance testing, multiple cylinders of concrete are test at how many days -
(answers)28 days
How is drip edge installed at an eave end? - (answers)under the felt
The main support under a wood deck is called a? - (answers)Girder
What is the correct way to test a safety net used for fall protection? -
(answers)Drop test with a 400 lb bag from the highest walking surface
How often must cranes in regular service be inspected for leakage in air or
hydraulic systems? - (answers)each shift
corbel - (answers)A projecting wall member used as a support for some element
in the superstructure.
Where shall the fireplace throat or damper be located? - (answers)at least 8
inches above the lintel
Lintel - (answers)A horizontal beam used to span an opening.
What is the best dozer to use for landscaping? - (answers)light utility dozer
, Header - (answers)A beam placed perpendicular to joists and to which joists are
nailed in framing for a chimney, stairway, or other opening.
joist - (answers)beam used to support floors or roofs
Soffit - (answers)in interior, area of room that is lower than the rest of the ceiling
soffit (exterior) - (answers)The underside of a roof overhang.
What is the maximum vertical rise between floor levels or landings for a flight of
stairs? - (answers)12 ft
What size landing shall be on each side of an exterior door? - (answers)The width
of each landing shall have a minimum dimension of 36 inches in the direction of
travel.
Before making a pass, what should the dozer be aligned with? - (answers)Blade
dump area
A cut stake is being set for the excavation of a trench using a building level
(transit). The bottom of the trench will be at elevation 94.00 feet. A rod reading of
4.70 feet is taken on a benchmark whose elevation is 102.50 feet. The rod reading
on the mark on the cut stake is 6.20 feet. What should the cut stake be marked? -
(answers)7.00
QUESTIONS AND ALL CORRECT
ANSWERS 100% SOLVED AND
GUARANTEED SUCCESS!!
What are masonry exterior non-load bearing walls that are not wholly supported
at each story? - (answers)Curtain Walls
Buildings shall have an attic access where attic areas exceed 30 sq feet and have a
vertical height of - (answers)30" or greater
The best piece of equipment to strip material over a long distance is a -
(answers)Scraper
The effect of loading uphill using a scraper is: - (answers)It increases cycle time
A building slab will be 25' x 90' x 8" How many cubic yards of concrete will be
needed? (Note: assume that the grade will be perfectly level and that there will
be no crown or slope in the slab do not include waste or accessing your estimate.
- (answers)56 yd
Block or stack bond is purely a _________ bond - (answers)Pattern
How much do concrete tiles weigh per square? - (answers)900 lbs
,For acceptance testing, multiple cylinders of concrete are test at how many days -
(answers)28 days
How is drip edge installed at an eave end? - (answers)under the felt
The main support under a wood deck is called a? - (answers)Girder
What is the correct way to test a safety net used for fall protection? -
(answers)Drop test with a 400 lb bag from the highest walking surface
How often must cranes in regular service be inspected for leakage in air or
hydraulic systems? - (answers)each shift
corbel - (answers)A projecting wall member used as a support for some element
in the superstructure.
Where shall the fireplace throat or damper be located? - (answers)at least 8
inches above the lintel
Lintel - (answers)A horizontal beam used to span an opening.
What is the best dozer to use for landscaping? - (answers)light utility dozer
, Header - (answers)A beam placed perpendicular to joists and to which joists are
nailed in framing for a chimney, stairway, or other opening.
joist - (answers)beam used to support floors or roofs
Soffit - (answers)in interior, area of room that is lower than the rest of the ceiling
soffit (exterior) - (answers)The underside of a roof overhang.
What is the maximum vertical rise between floor levels or landings for a flight of
stairs? - (answers)12 ft
What size landing shall be on each side of an exterior door? - (answers)The width
of each landing shall have a minimum dimension of 36 inches in the direction of
travel.
Before making a pass, what should the dozer be aligned with? - (answers)Blade
dump area
A cut stake is being set for the excavation of a trench using a building level
(transit). The bottom of the trench will be at elevation 94.00 feet. A rod reading of
4.70 feet is taken on a benchmark whose elevation is 102.50 feet. The rod reading
on the mark on the cut stake is 6.20 feet. What should the cut stake be marked? -
(answers)7.00
