1|Page
DHL INTERVIEW ATPL QUESTIONS WITH 100%
VERIFIED ANSWERS 2025
What is the VOR change over distance? -correct-answer-60NM
What is the minimum distance between parallel runways? -correct-answer-915m
what the key points of using Mode 2 for parallel runways? -correct-answer-Only
straight in approaches allowed
interception angle of no more that 30 degrees
must be straight and level 1NM for localiser
must be straight and level 2NM for Glideslope
Minimum separation of 3NM on same Loc
Min separation of 2 NM on adjacent Loc
Missed approach tracks diverge by at least 30 degree
what is the minimum time a flight plan must be filed before departure -correct-
answer-60 minutes
,2|Page
how does a pilot create a slip or a skid and how it is indicated on the turn co-
ordinator? -correct-answer-Slip - opposite rudder to direction of turn = ball will be
at the same side of the turn
Skid - too much rudder in the direction of the turn = ball will be on the opposite
side to the turn
what time must ATC clocks be within? -correct-answer-30 seconds
what are the Airspace separations rules for Class A -correct-answer-IFR Only
What are the Airspace separation rules for Class B -correct-answer-IFR and VFR
seperated
What are the Airspace separation rules for Class C -correct-answer-IFR separated
from IFR
IFR Separated from VFR
VFR Info about VFR
Speed limited below FL100 250kts
IFR ( speed limit only on ATC instruction)
,3|Page
What are the Airspace separation rules for Class D -correct-answer-IFR Separated
from VFR
IFR Info about VFR
VFR Info about VFR
Speed limit below FL100 250kts
what its the difference between class D and Class E airspace for VFR -correct-
answer-No ATC required
No SVFR
What is Load Shedding -correct-answer-Reducing electrical load on the system by
turning of unnecessary electrical components
how would an artificial feel unit be connected? -correct-answer-In Parallel
otherwise if it failed it would stop the system
what are booster pumps -correct-answer-low pressure centrifugal boots that
supply fuel to the engines.
, 4|Page
why are booster pumps important? -correct-answer-they prevent cavitation of the
engine driven pumps at high altitude.
what is the purpose of baffle valves -correct-answer-to prevent fuel flowing the
the wing tips to keep it in the centre near the pumps
what is a feeder box -correct-answer-a box arounds the booster pumps that keeps
the pumps submerged in fuel to prevent cavitation
how do you switch off the magneto -correct-answer-ground the primary circuit
how is the twin jet fuelled -correct-answer-by fuel being pumped from the fuel
truck
what type of fire extinguisher do you use on propane fire -correct-answer-foam
DHL INTERVIEW ATPL QUESTIONS WITH 100%
VERIFIED ANSWERS 2025
What is the VOR change over distance? -correct-answer-60NM
What is the minimum distance between parallel runways? -correct-answer-915m
what the key points of using Mode 2 for parallel runways? -correct-answer-Only
straight in approaches allowed
interception angle of no more that 30 degrees
must be straight and level 1NM for localiser
must be straight and level 2NM for Glideslope
Minimum separation of 3NM on same Loc
Min separation of 2 NM on adjacent Loc
Missed approach tracks diverge by at least 30 degree
what is the minimum time a flight plan must be filed before departure -correct-
answer-60 minutes
,2|Page
how does a pilot create a slip or a skid and how it is indicated on the turn co-
ordinator? -correct-answer-Slip - opposite rudder to direction of turn = ball will be
at the same side of the turn
Skid - too much rudder in the direction of the turn = ball will be on the opposite
side to the turn
what time must ATC clocks be within? -correct-answer-30 seconds
what are the Airspace separations rules for Class A -correct-answer-IFR Only
What are the Airspace separation rules for Class B -correct-answer-IFR and VFR
seperated
What are the Airspace separation rules for Class C -correct-answer-IFR separated
from IFR
IFR Separated from VFR
VFR Info about VFR
Speed limited below FL100 250kts
IFR ( speed limit only on ATC instruction)
,3|Page
What are the Airspace separation rules for Class D -correct-answer-IFR Separated
from VFR
IFR Info about VFR
VFR Info about VFR
Speed limit below FL100 250kts
what its the difference between class D and Class E airspace for VFR -correct-
answer-No ATC required
No SVFR
What is Load Shedding -correct-answer-Reducing electrical load on the system by
turning of unnecessary electrical components
how would an artificial feel unit be connected? -correct-answer-In Parallel
otherwise if it failed it would stop the system
what are booster pumps -correct-answer-low pressure centrifugal boots that
supply fuel to the engines.
, 4|Page
why are booster pumps important? -correct-answer-they prevent cavitation of the
engine driven pumps at high altitude.
what is the purpose of baffle valves -correct-answer-to prevent fuel flowing the
the wing tips to keep it in the centre near the pumps
what is a feeder box -correct-answer-a box arounds the booster pumps that keeps
the pumps submerged in fuel to prevent cavitation
how do you switch off the magneto -correct-answer-ground the primary circuit
how is the twin jet fuelled -correct-answer-by fuel being pumped from the fuel
truck
what type of fire extinguisher do you use on propane fire -correct-answer-foam
