Page 1 of 160
OWNER BUILDER EXAM TEST BANK WITH
COMPLETE 450 QUESTIONS AND CORRECT
VERIFIED ANSWERS JUST RELEASED THIS YEAR
QUESTION: What must a principle of a farm corporation do to
receive an HPO permit?
a. Must not sell land for one year
b. Request a rezoning of the property
c. File special resolution not to sell interest in land for 1yr
d. Owner builder cannot work with farming applications - ANSWER✔✔c
QUESTION: Which of the following best describes a chimney flue?
a. An intake for fresh air
b. Exhaust for a wood burning fireplace only
c. Manual vent for greater oxygen exposure
d. Opening for exhaust gases to exit - ANSWER✔✔d
QUESTION: What is the best practice for framing a foundation
a. Square corners first and brace
, Page 2 of 160
b. Cut twice, measure once
c. Hire a professional for all concrete pours
d. Get corners near square and adjust later - ANSWER✔✔a
QUESTION: How should you store a propane cylinders on a job site?
a. On their side
b. Upright and Secured
c. Dry and warm
d. Secured to the kettle - ANSWER✔✔b
QUESTION: What is the most appropriate bridging / blocking for a non-engineered floor?
a. Cross-bridging at 7' OC max
b. 2 x 4 at 6' OC max
c. Install continuous stiffeners 2' on center
d. Install vertical stiffeners at 2' - ANSWER✔✔a
QUESTION:If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of
entry and exit must be located:
, Page 3 of 160
a) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
b) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
c) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - ANSWER✔✔a
QUESTION: If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of
entry and exit must be located:
a) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
b) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
c) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - ANSWER✔✔c
, Page 4 of 160
QUESTION: What is the design and construction that prevents
water from ever entering?
a) Principle of driving rain deterrent
b) Principle of driving rain deflection
c) Principle of rainwater deterrent
d) Principle of rainwater deflection - ANSWER✔✔d
QUESTION: The higher grit number is equivalent to:
a) a finer abrasive, which creates smoother surface
finishes.
b) a finer abrasive, which creates a rougher surface finish.
c) a rougher abrasive, which creates smoother surface
finishes.
d) a rougher abrasive, which creates a rougher surface finish. - ANSWER✔✔a
QUESTION: The vertical height of any flight of stairs shall not exceed
a) 4.5 m or 15 ft
OWNER BUILDER EXAM TEST BANK WITH
COMPLETE 450 QUESTIONS AND CORRECT
VERIFIED ANSWERS JUST RELEASED THIS YEAR
QUESTION: What must a principle of a farm corporation do to
receive an HPO permit?
a. Must not sell land for one year
b. Request a rezoning of the property
c. File special resolution not to sell interest in land for 1yr
d. Owner builder cannot work with farming applications - ANSWER✔✔c
QUESTION: Which of the following best describes a chimney flue?
a. An intake for fresh air
b. Exhaust for a wood burning fireplace only
c. Manual vent for greater oxygen exposure
d. Opening for exhaust gases to exit - ANSWER✔✔d
QUESTION: What is the best practice for framing a foundation
a. Square corners first and brace
, Page 2 of 160
b. Cut twice, measure once
c. Hire a professional for all concrete pours
d. Get corners near square and adjust later - ANSWER✔✔a
QUESTION: How should you store a propane cylinders on a job site?
a. On their side
b. Upright and Secured
c. Dry and warm
d. Secured to the kettle - ANSWER✔✔b
QUESTION: What is the most appropriate bridging / blocking for a non-engineered floor?
a. Cross-bridging at 7' OC max
b. 2 x 4 at 6' OC max
c. Install continuous stiffeners 2' on center
d. Install vertical stiffeners at 2' - ANSWER✔✔a
QUESTION:If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of
entry and exit must be located:
, Page 3 of 160
a) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
b) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
c) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - ANSWER✔✔a
QUESTION: If workers are required to enter a trench over 1.2 m (4 ft) deep, the safe point of
entry and exit must be located:
a) within 5 m (16 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
b) within 7 m (23 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location.
c) within 8 m (25 ft) of the workers and the excavation must be
safely supported or sloped to the entry and exit location.
d) within 10 m (32 ft) of the workers and the excavation must be safely supported or sloped to
the entry and exit location. - ANSWER✔✔c
, Page 4 of 160
QUESTION: What is the design and construction that prevents
water from ever entering?
a) Principle of driving rain deterrent
b) Principle of driving rain deflection
c) Principle of rainwater deterrent
d) Principle of rainwater deflection - ANSWER✔✔d
QUESTION: The higher grit number is equivalent to:
a) a finer abrasive, which creates smoother surface
finishes.
b) a finer abrasive, which creates a rougher surface finish.
c) a rougher abrasive, which creates smoother surface
finishes.
d) a rougher abrasive, which creates a rougher surface finish. - ANSWER✔✔a
QUESTION: The vertical height of any flight of stairs shall not exceed
a) 4.5 m or 15 ft