Lockwasher?
Give this one a try later!
Loc-tite, Nylon insert.
, Diameters smaller than 1/4" use numbers in the U.S. What do these numbers
designate?
Give this one a try later!
(For diameters smaller than 1⁄4 inch, the) diameter is indicated by an
integer number defined in the standard. (This number pair is followed by
the letters UNC, UNF or UNEF if the diameter-pitch combination is from the
"coarse", "fine" or "extra fine" series, and may also be followed by a
tolerance class)
Anodizing is most commonly associated with what metals?
Give this one a try later!
Aluminum, magnesium, and titanium
What is the typical thickness of an electroplated coating?
Give this one a try later!
0.0001-0.0003 (nickel)
Ferrous will ______ (rust/corrode) and non-ferrous will ______ (rust/corrode).
Give this one a try later!
Give this one a try later!
Loc-tite, Nylon insert.
, Diameters smaller than 1/4" use numbers in the U.S. What do these numbers
designate?
Give this one a try later!
(For diameters smaller than 1⁄4 inch, the) diameter is indicated by an
integer number defined in the standard. (This number pair is followed by
the letters UNC, UNF or UNEF if the diameter-pitch combination is from the
"coarse", "fine" or "extra fine" series, and may also be followed by a
tolerance class)
Anodizing is most commonly associated with what metals?
Give this one a try later!
Aluminum, magnesium, and titanium
What is the typical thickness of an electroplated coating?
Give this one a try later!
0.0001-0.0003 (nickel)
Ferrous will ______ (rust/corrode) and non-ferrous will ______ (rust/corrode).
Give this one a try later!
