Safety & Operation Test: Jointer
Questions & Answers
1. Which of the following jobs cannot be done with the jointer?
a. Rabbeting
b. Chamfering
c. Grooving
d. Beveling - ANSWERSc. Grooving
2. Before leaving the jointer, one should ___.
a. have the cutterhead guard in place
b. turn the switch to the Off position
c. make sure the cutterhead has stopped turning
d. all of the above - ANSWERSd. all of the above
3. The maximum cut recommended of one pass with the jointer on softwoods is ___.
a. 1/32 inch
b. 1/16 inch
c. 3/16 inch
d. 1/4 inch - ANSWERSa. 1/32 inch
4. The primary purpose of the jointer in the agricultural mechanics shop is to ___.
a. cut rabbets
b. edge stock
c. cut chamfers
d. cut bevels - ANSWERSb. edge stock
5. Which of the following operation(s) cannot be done with the cutter-head guard in
place?
a. Edging
b. Beveling
c. Rabbeting
d. All of the above - ANSWERSc. Rabbeting
Questions & Answers
1. Which of the following jobs cannot be done with the jointer?
a. Rabbeting
b. Chamfering
c. Grooving
d. Beveling - ANSWERSc. Grooving
2. Before leaving the jointer, one should ___.
a. have the cutterhead guard in place
b. turn the switch to the Off position
c. make sure the cutterhead has stopped turning
d. all of the above - ANSWERSd. all of the above
3. The maximum cut recommended of one pass with the jointer on softwoods is ___.
a. 1/32 inch
b. 1/16 inch
c. 3/16 inch
d. 1/4 inch - ANSWERSa. 1/32 inch
4. The primary purpose of the jointer in the agricultural mechanics shop is to ___.
a. cut rabbets
b. edge stock
c. cut chamfers
d. cut bevels - ANSWERSb. edge stock
5. Which of the following operation(s) cannot be done with the cutter-head guard in
place?
a. Edging
b. Beveling
c. Rabbeting
d. All of the above - ANSWERSc. Rabbeting
