1 of 35
Term
In most process control systems the process measurement is derived
by a:
Give this one a try later!
Thermistor Control
, Actuator Sensor
Don't know?
2 of 35
Term
Calibration equipment must be ________ in order to be used to calibrate
process instruments
Give this one a try later!
A bubbler does not require either Subtract the reference junction
elevation or suppression to function millivolts from the instruments
properly voltage readings
1. Newer than the instrument to
be calibrated The square of the percentage of
2. More accurate than the maximum flow rate
instrument(s) to be calibrated
Don't know?
3 of 35
Term
, An increase in the viscosity of a liquid will result in a _______ Reynolds
number
Give this one a try later!
Lower Unchanged
Higher Variable
Don't know?
4 of 35
Term
Loss of signal from the compensation lead of a smart temperature
transmitter with a three wire RTD will usually cause an output condition
which will be:
Give this one a try later!
Dependent upon the setting of
Always outputs a maximum signal
the failure mode
Randomly fluctuates without pattern Completely lost and unresponsive
Don't know?
Term
In most process control systems the process measurement is derived
by a:
Give this one a try later!
Thermistor Control
, Actuator Sensor
Don't know?
2 of 35
Term
Calibration equipment must be ________ in order to be used to calibrate
process instruments
Give this one a try later!
A bubbler does not require either Subtract the reference junction
elevation or suppression to function millivolts from the instruments
properly voltage readings
1. Newer than the instrument to
be calibrated The square of the percentage of
2. More accurate than the maximum flow rate
instrument(s) to be calibrated
Don't know?
3 of 35
Term
, An increase in the viscosity of a liquid will result in a _______ Reynolds
number
Give this one a try later!
Lower Unchanged
Higher Variable
Don't know?
4 of 35
Term
Loss of signal from the compensation lead of a smart temperature
transmitter with a three wire RTD will usually cause an output condition
which will be:
Give this one a try later!
Dependent upon the setting of
Always outputs a maximum signal
the failure mode
Randomly fluctuates without pattern Completely lost and unresponsive
Don't know?
