Chapter 125 - Alignment diagnosis and Service Question
and answers verified to pass 2025
1. Tech A says that if a pull occurs
Tech B only - Torque steer
sometimes to the left, and sometimes
occurs in front-wheel-drive-
to the right dur- ing acceleration, this
vehicles when engine
is called torque steer. Tech B says if a
torque causes a front wheel to change
vehicle pulls to one side only during
its angle from straight ahead. This is
acceleration then this is called
most no- ticeable during rapid
torque steer. Which tech is correct?
acceleration.
2. Which angle is the largest? 45 minutes
3. If the trust line is leaning on the pull toward the right and feather-edge
right from the geometric center line, both tires
then the vehicle will .
4. After the vehicle is set up on the alignment caster sweep
rack, perform a to check front caster.
5. A four-wheel alignment allows the aftermarket kit
to be adjusted to zero.
6. Tech A says that the thrust line
alignment is required for any
vehicle with a nonad- justable rear
suspension. Tech B says that a
tolerance adjustment involves
removing and reinstalling subframe
bolts. Which tech is correct?
7. Which alignment procedure may be
done using self-calibration?
8. Tech A says that a vehicle with
modified suspension may need an
1/
5
, Chapter 125 - Alignment diagnosis and Service Question
and answers verified to pass 2025
thrust line
steering angle sensor (SAS)
Tech A only - a thrust line alignment is re- quired for any
vehicle with nonadjustable rear suspension. Tech A only - a vehicle with
modified sus- pension will need an
aftermarket kit to
installed to achieve the specified alignment achieve specified alignment
settings.
settings. Tech B says that the radar cruise
2/
5
and answers verified to pass 2025
1. Tech A says that if a pull occurs
Tech B only - Torque steer
sometimes to the left, and sometimes
occurs in front-wheel-drive-
to the right dur- ing acceleration, this
vehicles when engine
is called torque steer. Tech B says if a
torque causes a front wheel to change
vehicle pulls to one side only during
its angle from straight ahead. This is
acceleration then this is called
most no- ticeable during rapid
torque steer. Which tech is correct?
acceleration.
2. Which angle is the largest? 45 minutes
3. If the trust line is leaning on the pull toward the right and feather-edge
right from the geometric center line, both tires
then the vehicle will .
4. After the vehicle is set up on the alignment caster sweep
rack, perform a to check front caster.
5. A four-wheel alignment allows the aftermarket kit
to be adjusted to zero.
6. Tech A says that the thrust line
alignment is required for any
vehicle with a nonad- justable rear
suspension. Tech B says that a
tolerance adjustment involves
removing and reinstalling subframe
bolts. Which tech is correct?
7. Which alignment procedure may be
done using self-calibration?
8. Tech A says that a vehicle with
modified suspension may need an
1/
5
, Chapter 125 - Alignment diagnosis and Service Question
and answers verified to pass 2025
thrust line
steering angle sensor (SAS)
Tech A only - a thrust line alignment is re- quired for any
vehicle with nonadjustable rear suspension. Tech A only - a vehicle with
modified sus- pension will need an
aftermarket kit to
installed to achieve the specified alignment achieve specified alignment
settings.
settings. Tech B says that the radar cruise
2/
5
