NACE CIP Level 1 NACE-CIP1-001 Practice Test – Killtest Questions and Answers

NACE CIP Level 1 NACE-CIP1-001
Practice Test – Killtest



You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank
lining is being applied. After application of the 19 coat you notice small blisters in some
areas of the applied lining.
Your FIRST preferred course of action is to:
A. Break the blisters to see what's inside
B. Document the problem and advise the Contractor and Owner's representative
C. Document the problem and advise the Contractor
D. Extract any liquid that may be inside the blister and send it to the lab for further
analysis - Correct Answers -B. Document the problem and advise the Contractor and
Owner's representative

Dew point is the temperature at which
A. water freezes.
B. humidity decreases
C. condensation occurs.
D. the air is saturated. - Correct Answers -C. condensation occurs.

Galvanic corrosion occurs on which of the following substrates:
A. Concrete
B. Fiberglass Reinforced Plastic
C. Metal
D. Wood - Correct Answers -C. Metal

When applying Thermal Spray Coatings the specification is most likely to refence:
A. SSPC PA 2
B. NACE SP 0178
C. NACE SP 0188
D. SSPC-CS 23.00/AWS C2.23/NACE No. 12 - Correct Answers -D. SSPC-CS
23.00/AWS C2.23/NACE No. 12

What is the minimum recommended distance away from an edge that an inspector
should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT)
gauge?
A. 1 cm (.39 inch)
B. 2.5 cm (1 inch)
C. 6.35 cm (2.5 inch)