ABX B767 Systems Review Exam Questions and Answers 100% Pass

ABX B767 Systems Review Exam Questions and Answers 100% Pass Max operating pressure altitude - 43,100 When will the RETURN TO SEAT sign illuminate with selector in AUTO - When flaps are extended Also have aural chime Before opening forward door, what must first be accomplished - Pull green lever to disarm slide. Max airspeed for operating No. 2 cockpit window - 250 knots When the LT OVRD switch is selected on, which cockpit lights will oeprate - Cpt and FO instrument flood lights. Fwd and Aft dome lights. 2 100% Pass Guarantee Katelyn Whitman, All Rights Which EICAS computer is normally controlling the CRT's when selector in AUTO - Left EICAS computer How is a warning presented on the upper CRT - A warning message is displayed in red letters What conditions will cause a siren to sound - Cabin Alt > 10,000 A/P disconnect Configuration Warning Overspeed Main Cargo Door What indicates more than one page is available - "Page 1" displayed, push cancel button to go to page 2 on EICAS How are messages cancelled and recalled - Push cancel switch to hide messages. Push recall to bring back. Cannot hide warnings. 3 100% Pass Guarantee Katelyn Whitman, All Rights During which portion of flight is fire bell and Master warning inhibited - From nose gear extension to 400 feet or 20 seconds, whichever occurs first What indications show a new status message is available - A status cue appears in the upper left corner of the lower CRT if status page not selected When may a status message be erased and how is this accomplished - Erase on the ground, during preflight. On access panel press "ecs" "auto" "erase" What actions must the flight crew take if a status message appears on taxi, before take off - Attempt status message clearing Refer to MEL What actions will cause the stick nudger to operate - It at stick shaker, flaps retracted and AOA continues to increase column nudger moves forward What happens if 1 CRT fails when full up engine indications are displayed - EICAS DISPLAY message 4 100% Pass Guarantee Katelyn Whitman, All Rights Engine indications and alert messages appear on operable display in compact mode When the computer is selected in AUTO, what happens if the left EICAS computer fails - It will switch to right computer What conditions will cause a Take Off Configuration Warning - LE slats not in take off position Flaps not in take off position Slat/flap position disagrees with flap lever position Stabilizer position outside take off range Speed brake lever not in detent When take off configuration horn is activated, how may it be silenced - Reconfigure What conditions will cause a landing configuration warning - Landing Gear not down and locked AND below 800', thrust levers idle 5 100% Pass Guarantee Katelyn Whitman, All Rights OR landing flaps selected If any of the landing gear not down and locked, how may the landing configuration horn be inhibited - push GRNDPROX/CONFIG GEAR OVRD switch What must be accomplished to silence an overspeed warning - reduce speed What are the indications for a decreasing performance wind shear - Red windshear light on upper EICAS Red windshear message on each pilot ADI